1/* SPDX-License-Identifier: GPL-2.0 */ 2#ifndef _DVB_USB_DIGITV_H_ 3#define _DVB_USB_DIGITV_H_ 4 5#define DVB_USB_LOG_PREFIX "digitv" 6#include "dvb-usb.h" 7 8struct digitv_state { 9 int is_nxt6000; 10}; 11 12/* protocol (from usblogging and the SDK: 13 * 14 * Always 7 bytes bulk message(s) for controlling 15 * 16 * First byte describes the command. Reads are 2 consecutive transfer (as always). 17 * 18 * General structure: 19 * 20 * write or first message of a read: 21 * <cmdbyte> VV <len> B0 B1 B2 B3 22 * 23 * second message of a read 24 * <cmdbyte> VV <len> R0 R1 R2 R3 25 * 26 * whereas 0 < len <= 4 27 * 28 * I2C address is stored somewhere inside the device. 29 * 30 * 0x01 read from EEPROM 31 * VV = offset; B* = 0; R* = value(s) 32 * 33 * 0x02 read register of the COFDM 34 * VV = register; B* = 0; R* = value(s) 35 * 36 * 0x05 write register of the COFDM 37 * VV = register; B* = value(s); 38 * 39 * 0x06 write to the tuner (only for NXT6000) 40 * VV = 0; B* = PLL data; len = 4; 41 * 42 * 0x03 read remote control 43 * VV = 0; B* = 0; len = 4; R* = key 44 * 45 * 0x07 write to the remote (don't know why one should this, resetting ?) 46 * VV = 0; B* = key; len = 4; 47 * 48 * 0x08 write remote type 49 * VV = 0; B[0] = 0x01, len = 4 50 * 51 * 0x09 write device init 52 * TODO 53 */ 54#define USB_READ_EEPROM 1 55 56#define USB_READ_COFDM 2 57#define USB_WRITE_COFDM 5 58 59#define USB_WRITE_TUNER 6 60 61#define USB_READ_REMOTE 3 62#define USB_WRITE_REMOTE 7 63#define USB_WRITE_REMOTE_TYPE 8 64 65#define USB_DEV_INIT 9 66 67#endif 68