1// SPDX-License-Identifier: GPL-2.0+ 2/* 3 * Copyright (C) 2004 by Thomas Rathbone, HP Labs 4 * Copyright (C) 2005 by Ivan Kokshaysky 5 * Copyright (C) 2006 by SAN People 6 */ 7 8#ifndef AT91_UDC_H 9#define AT91_UDC_H 10 11/* 12 * USB Device Port (UDP) registers. 13 * Based on AT91RM9200 datasheet revision E. 14 */ 15 16#define AT91_UDP_FRM_NUM 0x00 /* Frame Number Register */ 17#define AT91_UDP_NUM (0x7ff << 0) /* Frame Number */ 18#define AT91_UDP_FRM_ERR (1 << 16) /* Frame Error */ 19#define AT91_UDP_FRM_OK (1 << 17) /* Frame OK */ 20 21#define AT91_UDP_GLB_STAT 0x04 /* Global State Register */ 22#define AT91_UDP_FADDEN (1 << 0) /* Function Address Enable */ 23#define AT91_UDP_CONFG (1 << 1) /* Configured */ 24#define AT91_UDP_ESR (1 << 2) /* Enable Send Resume */ 25#define AT91_UDP_RSMINPR (1 << 3) /* Resume has been sent */ 26#define AT91_UDP_RMWUPE (1 << 4) /* Remote Wake Up Enable */ 27 28#define AT91_UDP_FADDR 0x08 /* Function Address Register */ 29#define AT91_UDP_FADD (0x7f << 0) /* Function Address Value */ 30#define AT91_UDP_FEN (1 << 8) /* Function Enable */ 31 32#define AT91_UDP_IER 0x10 /* Interrupt Enable Register */ 33#define AT91_UDP_IDR 0x14 /* Interrupt Disable Register */ 34#define AT91_UDP_IMR 0x18 /* Interrupt Mask Register */ 35 36#define AT91_UDP_ISR 0x1c /* Interrupt Status Register */ 37#define AT91_UDP_EP(n) (1 << (n)) /* Endpoint Interrupt Status */ 38#define AT91_UDP_RXSUSP (1 << 8) /* USB Suspend Interrupt Status */ 39#define AT91_UDP_RXRSM (1 << 9) /* USB Resume Interrupt Status */ 40#define AT91_UDP_EXTRSM (1 << 10) /* External Resume Interrupt Status [AT91RM9200 only] */ 41#define AT91_UDP_SOFINT (1 << 11) /* Start of Frame Interrupt Status */ 42#define AT91_UDP_ENDBUSRES (1 << 12) /* End of Bus Reset Interrupt Status */ 43#define AT91_UDP_WAKEUP (1 << 13) /* USB Wakeup Interrupt Status [AT91RM9200 only] */ 44 45#define AT91_UDP_ICR 0x20 /* Interrupt Clear Register */ 46#define AT91_UDP_RST_EP 0x28 /* Reset Endpoint Register */ 47 48#define AT91_UDP_CSR(n) (0x30+((n)*4)) /* Endpoint Control/Status Registers 0-7 */ 49#define AT91_UDP_TXCOMP (1 << 0) /* Generates IN packet with data previously written in DPR */ 50#define AT91_UDP_RX_DATA_BK0 (1 << 1) /* Receive Data Bank 0 */ 51#define AT91_UDP_RXSETUP (1 << 2) /* Send STALL to the host */ 52#define AT91_UDP_STALLSENT (1 << 3) /* Stall Sent / Isochronous error (Isochronous endpoints) */ 53#define AT91_UDP_TXPKTRDY (1 << 4) /* Transmit Packet Ready */ 54#define AT91_UDP_FORCESTALL (1 << 5) /* Force Stall */ 55#define AT91_UDP_RX_DATA_BK1 (1 << 6) /* Receive Data Bank 1 */ 56#define AT91_UDP_DIR (1 << 7) /* Transfer Direction */ 57#define AT91_UDP_EPTYPE (7 << 8) /* Endpoint Type */ 58#define AT91_UDP_EPTYPE_CTRL (0 << 8) 59#define AT91_UDP_EPTYPE_ISO_OUT (1 << 8) 60#define AT91_UDP_EPTYPE_BULK_OUT (2 << 8) 61#define AT91_UDP_EPTYPE_INT_OUT (3 << 8) 62#define AT91_UDP_EPTYPE_ISO_IN (5 << 8) 63#define AT91_UDP_EPTYPE_BULK_IN (6 << 8) 64#define AT91_UDP_EPTYPE_INT_IN (7 << 8) 65#define AT91_UDP_DTGLE (1 << 11) /* Data Toggle */ 66#define AT91_UDP_EPEDS (1 << 15) /* Endpoint Enable/Disable */ 67#define AT91_UDP_RXBYTECNT (0x7ff << 16) /* Number of bytes in FIFO */ 68 69#define AT91_UDP_FDR(n) (0x50+((n)*4)) /* Endpoint FIFO Data Registers 0-7 */ 70 71#define AT91_UDP_TXVC 0x74 /* Transceiver Control Register */ 72#define AT91_UDP_TXVC_TXVDIS (1 << 8) /* Transceiver Disable */ 73#define AT91_UDP_TXVC_PUON (1 << 9) /* PullUp On [AT91SAM9260 only] */ 74 75/*-------------------------------------------------------------------------*/ 76 77/* 78 * controller driver data structures 79 */ 80 81#define NUM_ENDPOINTS 6 82 83/* 84 * hardware won't disable bus reset, or resume while the controller 85 * is suspended ... watching suspend helps keep the logic symmetric. 86 */ 87#define MINIMUS_INTERRUPTUS \ 88 (AT91_UDP_ENDBUSRES | AT91_UDP_RXRSM | AT91_UDP_RXSUSP) 89 90struct at91_ep { 91 struct usb_ep ep; 92 struct list_head queue; 93 struct at91_udc *udc; 94 void __iomem *creg; 95 96 unsigned maxpacket:16; 97 u8 int_mask; 98 unsigned is_pingpong:1; 99 100 unsigned stopped:1; 101 unsigned is_in:1; 102 unsigned is_iso:1; 103 unsigned fifo_bank:1; 104}; 105 106struct at91_udc_caps { 107 int (*init)(struct at91_udc *udc); 108 void (*pullup)(struct at91_udc *udc, int is_on); 109}; 110 111struct at91_udc_data { 112 int vbus_pin; /* high == host powering us */ 113 u8 vbus_active_low; /* vbus polarity */ 114 u8 vbus_polled; /* Use polling, not interrupt */ 115 int pullup_pin; /* active == D+ pulled up */ 116 u8 pullup_active_low; /* true == pullup_pin is active low */ 117}; 118 119/* 120 * driver is non-SMP, and just blocks IRQs whenever it needs 121 * access protection for chip registers or driver state 122 */ 123struct at91_udc { 124 struct usb_gadget gadget; 125 struct at91_ep ep[NUM_ENDPOINTS]; 126 struct usb_gadget_driver *driver; 127 const struct at91_udc_caps *caps; 128 unsigned vbus:1; 129 unsigned enabled:1; 130 unsigned clocked:1; 131 unsigned suspended:1; 132 unsigned req_pending:1; 133 unsigned wait_for_addr_ack:1; 134 unsigned wait_for_config_ack:1; 135 unsigned active_suspend:1; 136 u8 addr; 137 struct at91_udc_data board; 138 struct clk *iclk, *fclk; 139 struct platform_device *pdev; 140 struct proc_dir_entry *pde; 141 void __iomem *udp_baseaddr; 142 int udp_irq; 143 spinlock_t lock; 144 struct timer_list vbus_timer; 145 struct work_struct vbus_timer_work; 146 struct regmap *matrix; 147}; 148 149static inline struct at91_udc *to_udc(struct usb_gadget *g) 150{ 151 return container_of(g, struct at91_udc, gadget); 152} 153 154struct at91_request { 155 struct usb_request req; 156 struct list_head queue; 157}; 158 159/*-------------------------------------------------------------------------*/ 160 161#ifdef VERBOSE_DEBUG 162# define VDBG DBG 163#else 164# define VDBG(stuff...) do{}while(0) 165#endif 166 167#ifdef PACKET_TRACE 168# define PACKET VDBG 169#else 170# define PACKET(stuff...) do{}while(0) 171#endif 172 173#define ERR(stuff...) pr_err("udc: " stuff) 174#define WARNING(stuff...) pr_warn("udc: " stuff) 175#define INFO(stuff...) pr_info("udc: " stuff) 176#define DBG(stuff...) pr_debug("udc: " stuff) 177 178#endif 179 180