linux/arch/arm/mach-omap1/board-voiceblue.c
<<
>>
Prefs
   1/*
   2 * linux/arch/arm/mach-omap1/board-voiceblue.c
   3 *
   4 * Modified from board-generic.c
   5 *
   6 * Copyright (C) 2004 2N Telekomunikace, Ladislav Michl <michl@2n.cz>
   7 *
   8 * Code for OMAP5910 based VoiceBlue board (VoIP to GSM gateway).
   9 *
  10 * This program is free software; you can redistribute it and/or modify
  11 * it under the terms of the GNU General Public License version 2 as
  12 * published by the Free Software Foundation.
  13 */
  14
  15#include <linux/delay.h>
  16#include <linux/platform_device.h>
  17#include <linux/interrupt.h>
  18#include <linux/irq.h>
  19#include <linux/init.h>
  20#include <linux/kernel.h>
  21#include <linux/notifier.h>
  22#include <linux/reboot.h>
  23#include <linux/serial_8250.h>
  24#include <linux/serial_reg.h>
  25
  26#include <mach/hardware.h>
  27#include <asm/mach-types.h>
  28#include <asm/mach/arch.h>
  29#include <asm/mach/flash.h>
  30#include <asm/mach/map.h>
  31
  32#include <mach/common.h>
  33#include <mach/gpio.h>
  34#include <mach/mux.h>
  35#include <mach/tc.h>
  36#include <mach/usb.h>
  37
  38static struct plat_serial8250_port voiceblue_ports[] = {
  39        {
  40                .mapbase        = (unsigned long)(OMAP_CS1_PHYS + 0x40000),
  41                .irq            = OMAP_GPIO_IRQ(12),
  42                .flags          = UPF_BOOT_AUTOCONF | UPF_IOREMAP,
  43                .iotype         = UPIO_MEM,
  44                .regshift       = 1,
  45                .uartclk        = 3686400,
  46        },
  47        {
  48                .mapbase        = (unsigned long)(OMAP_CS1_PHYS + 0x50000),
  49                .irq            = OMAP_GPIO_IRQ(13),
  50                .flags          = UPF_BOOT_AUTOCONF | UPF_IOREMAP,
  51                .iotype         = UPIO_MEM,
  52                .regshift       = 1,
  53                .uartclk        = 3686400,
  54        },
  55        {
  56                .mapbase        = (unsigned long)(OMAP_CS1_PHYS + 0x60000),
  57                .irq            = OMAP_GPIO_IRQ(14),
  58                .flags          = UPF_BOOT_AUTOCONF | UPF_IOREMAP,
  59                .iotype         = UPIO_MEM,
  60                .regshift       = 1,
  61                .uartclk        = 3686400,
  62        },
  63        {
  64                .mapbase        = (unsigned long)(OMAP_CS1_PHYS + 0x70000),
  65                .irq            = OMAP_GPIO_IRQ(15),
  66                .flags          = UPF_BOOT_AUTOCONF | UPF_IOREMAP,
  67                .iotype         = UPIO_MEM,
  68                .regshift       = 1,
  69                .uartclk        = 3686400,
  70        },
  71        { },
  72};
  73
  74static struct platform_device serial_device = {
  75        .name                   = "serial8250",
  76        .id                     = PLAT8250_DEV_PLATFORM1,
  77        .dev                    = {
  78                .platform_data  = voiceblue_ports,
  79        },
  80};
  81
  82static int __init ext_uart_init(void)
  83{
  84        return platform_device_register(&serial_device);
  85}
  86arch_initcall(ext_uart_init);
  87
  88static struct flash_platform_data voiceblue_flash_data = {
  89        .map_name       = "cfi_probe",
  90        .width          = 2,
  91};
  92
  93static struct resource voiceblue_flash_resource = {
  94        .start  = OMAP_CS0_PHYS,
  95        .end    = OMAP_CS0_PHYS + SZ_32M - 1,
  96        .flags  = IORESOURCE_MEM,
  97};
  98
  99static struct platform_device voiceblue_flash_device = {
 100        .name           = "omapflash",
 101        .id             = 0,
 102        .dev            = {
 103                .platform_data  = &voiceblue_flash_data,
 104        },
 105        .num_resources  = 1,
 106        .resource       = &voiceblue_flash_resource,
 107};
 108
 109static struct resource voiceblue_smc91x_resources[] = {
 110        [0] = {
 111                .start  = OMAP_CS2_PHYS + 0x300,
 112                .end    = OMAP_CS2_PHYS + 0x300 + 16,
 113                .flags  = IORESOURCE_MEM,
 114        },
 115        [1] = {
 116                .start  = OMAP_GPIO_IRQ(8),
 117                .end    = OMAP_GPIO_IRQ(8),
 118                .flags  = IORESOURCE_IRQ | IORESOURCE_IRQ_HIGHEDGE,
 119        },
 120};
 121
 122static struct platform_device voiceblue_smc91x_device = {
 123        .name           = "smc91x",
 124        .id             = 0,
 125        .num_resources  = ARRAY_SIZE(voiceblue_smc91x_resources),
 126        .resource       = voiceblue_smc91x_resources,
 127};
 128
 129static struct platform_device *voiceblue_devices[] __initdata = {
 130        &voiceblue_flash_device,
 131        &voiceblue_smc91x_device,
 132};
 133
 134static struct omap_usb_config voiceblue_usb_config __initdata = {
 135        .hmc_mode       = 3,
 136        .register_host  = 1,
 137        .register_dev   = 1,
 138        .pins[0]        = 2,
 139        .pins[1]        = 6,
 140        .pins[2]        = 6,
 141};
 142
 143static struct omap_board_config_kernel voiceblue_config[] = {
 144};
 145
 146static void __init voiceblue_init_irq(void)
 147{
 148        omap1_init_common_hw();
 149        omap_init_irq();
 150        omap_gpio_init();
 151}
 152
 153static void __init voiceblue_init(void)
 154{
 155        /* mux pins for uarts */
 156        omap_cfg_reg(UART1_TX);
 157        omap_cfg_reg(UART1_RTS);
 158        omap_cfg_reg(UART2_TX);
 159        omap_cfg_reg(UART2_RTS);
 160        omap_cfg_reg(UART3_TX);
 161        omap_cfg_reg(UART3_RX);
 162
 163        /* Watchdog */
 164        gpio_request(0, "Watchdog");
 165        /* smc91x reset */
 166        gpio_request(7, "SMC91x reset");
 167        gpio_direction_output(7, 1);
 168        udelay(2);      /* wait at least 100ns */
 169        gpio_set_value(7, 0);
 170        mdelay(50);     /* 50ms until PHY ready */
 171        /* smc91x interrupt pin */
 172        gpio_request(8, "SMC91x irq");
 173        /* 16C554 reset*/
 174        gpio_request(6, "16C554 reset");
 175        gpio_direction_output(6, 0);
 176        /* 16C554 interrupt pins */
 177        gpio_request(12, "16C554 irq");
 178        gpio_request(13, "16C554 irq");
 179        gpio_request(14, "16C554 irq");
 180        gpio_request(15, "16C554 irq");
 181        set_irq_type(gpio_to_irq(12), IRQ_TYPE_EDGE_RISING);
 182        set_irq_type(gpio_to_irq(13), IRQ_TYPE_EDGE_RISING);
 183        set_irq_type(gpio_to_irq(14), IRQ_TYPE_EDGE_RISING);
 184        set_irq_type(gpio_to_irq(15), IRQ_TYPE_EDGE_RISING);
 185
 186        platform_add_devices(voiceblue_devices, ARRAY_SIZE(voiceblue_devices));
 187        omap_board_config = voiceblue_config;
 188        omap_board_config_size = ARRAY_SIZE(voiceblue_config);
 189        omap_serial_init();
 190        omap_usb_init(&voiceblue_usb_config);
 191        omap_register_i2c_bus(1, 100, NULL, 0);
 192
 193        /* There is a good chance board is going up, so enable power LED
 194         * (it is connected through invertor) */
 195        omap_writeb(0x00, OMAP_LPG1_LCR);
 196        omap_writeb(0x00, OMAP_LPG1_PMR);       /* Disable clock */
 197}
 198
 199static void __init voiceblue_map_io(void)
 200{
 201        omap1_map_common_io();
 202}
 203
 204#define MACHINE_PANICED         1
 205#define MACHINE_REBOOTING       2
 206#define MACHINE_REBOOT          4
 207static unsigned long machine_state;
 208
 209static int panic_event(struct notifier_block *this, unsigned long event,
 210         void *ptr)
 211{
 212        if (test_and_set_bit(MACHINE_PANICED, &machine_state))
 213                return NOTIFY_DONE;
 214
 215        /* Flash power LED */
 216        omap_writeb(0x78, OMAP_LPG1_LCR);
 217        omap_writeb(0x01, OMAP_LPG1_PMR);       /* Enable clock */
 218
 219        return NOTIFY_DONE;
 220}
 221
 222static struct notifier_block panic_block = {
 223        .notifier_call  = panic_event,
 224};
 225
 226static int __init voiceblue_setup(void)
 227{
 228        /* Setup panic notifier */
 229        atomic_notifier_chain_register(&panic_notifier_list, &panic_block);
 230
 231        return 0;
 232}
 233postcore_initcall(voiceblue_setup);
 234
 235static int wdt_gpio_state;
 236
 237void voiceblue_wdt_enable(void)
 238{
 239        gpio_direction_output(0, 0);
 240        gpio_set_value(0, 1);
 241        gpio_set_value(0, 0);
 242        wdt_gpio_state = 0;
 243}
 244
 245void voiceblue_wdt_disable(void)
 246{
 247        gpio_set_value(0, 0);
 248        gpio_set_value(0, 1);
 249        gpio_set_value(0, 0);
 250        gpio_direction_input(0);
 251}
 252
 253void voiceblue_wdt_ping(void)
 254{
 255        if (test_bit(MACHINE_REBOOT, &machine_state))
 256                return;
 257
 258        wdt_gpio_state = !wdt_gpio_state;
 259        gpio_set_value(0, wdt_gpio_state);
 260}
 261
 262void voiceblue_reset(void)
 263{
 264        set_bit(MACHINE_REBOOT, &machine_state);
 265        voiceblue_wdt_enable();
 266        while (1) ;
 267}
 268
 269EXPORT_SYMBOL(voiceblue_wdt_enable);
 270EXPORT_SYMBOL(voiceblue_wdt_disable);
 271EXPORT_SYMBOL(voiceblue_wdt_ping);
 272
 273MACHINE_START(VOICEBLUE, "VoiceBlue OMAP5910")
 274        /* Maintainer: Ladislav Michl <michl@2n.cz> */
 275        .phys_io        = 0xfff00000,
 276        .io_pg_offst    = ((0xfef00000) >> 18) & 0xfffc,
 277        .boot_params    = 0x10000100,
 278        .map_io         = voiceblue_map_io,
 279        .init_irq       = voiceblue_init_irq,
 280        .init_machine   = voiceblue_init,
 281        .timer          = &omap_timer,
 282MACHINE_END
 283