LXR linux/include/uapi/linux/scc.h

   1/* $Id: scc.h,v 1.29 1997/04/02 14:56:45 jreuter Exp jreuter $ */
   2
   3#ifndef _UAPI_SCC_H
   4#define _UAPI_SCC_H
   5
   6
   7/* selection of hardware types */
   8
   9#define PA0HZP          0x00    /* hardware type for PA0HZP SCC card and compatible */
  10#define EAGLE           0x01    /* hardware type for EAGLE card */
  11#define PC100           0x02    /* hardware type for PC100 card */
  12#define PRIMUS          0x04    /* hardware type for PRIMUS-PC (DG9BL) card */
  13#define DRSI            0x08    /* hardware type for DRSI PC*Packet card */
  14#define BAYCOM          0x10    /* hardware type for BayCom (U)SCC */
  15
  16/* DEV ioctl() commands */
  17
  18enum SCC_ioctl_cmds {
  19        SIOCSCCRESERVED = SIOCDEVPRIVATE,
  20        SIOCSCCCFG,
  21        SIOCSCCINI,
  22        SIOCSCCCHANINI,
  23        SIOCSCCSMEM,
  24        SIOCSCCGKISS,
  25        SIOCSCCSKISS,
  26        SIOCSCCGSTAT,
  27        SIOCSCCCAL
  28};
  29
  30/* Device parameter control (from WAMPES) */
  31
  32enum L1_params {
  33        PARAM_DATA,
  34        PARAM_TXDELAY,
  35        PARAM_PERSIST,
  36        PARAM_SLOTTIME,
  37        PARAM_TXTAIL,
  38        PARAM_FULLDUP,
  39        PARAM_SOFTDCD,          /* was: PARAM_HW */
  40        PARAM_MUTE,             /* ??? */
  41        PARAM_DTR,
  42        PARAM_RTS,
  43        PARAM_SPEED,
  44        PARAM_ENDDELAY,         /* ??? */
  45        PARAM_GROUP,
  46        PARAM_IDLE,
  47        PARAM_MIN,
  48        PARAM_MAXKEY,
  49        PARAM_WAIT,
  50        PARAM_MAXDEFER,
  51        PARAM_TX,
  52        PARAM_HWEVENT = 31,
  53        PARAM_RETURN = 255      /* reset kiss mode */
  54};
  55
  56/* fulldup parameter */
  57
  58enum FULLDUP_modes {
  59        KISS_DUPLEX_HALF,       /* normal CSMA operation */
  60        KISS_DUPLEX_FULL,       /* fullduplex, key down trx after transmission */
  61        KISS_DUPLEX_LINK,       /* fullduplex, key down trx after 'idletime' sec */
  62        KISS_DUPLEX_OPTIMA      /* fullduplex, let the protocol layer control the hw */
  63};
  64
  65/* misc. parameters */
  66
  67#define TIMER_OFF       65535U  /* to switch off timers */
  68#define NO_SUCH_PARAM   65534U  /* param not implemented */
  69
  70/* HWEVENT parameter */
  71
  72enum HWEVENT_opts {
  73        HWEV_DCD_ON,
  74        HWEV_DCD_OFF,
  75        HWEV_ALL_SENT
  76};
  77
  78/* channel grouping */
  79
  80#define RXGROUP         0100    /* if set, only tx when all channels clear */
  81#define TXGROUP         0200    /* if set, don't transmit simultaneously */
  82
  83/* Tx/Rx clock sources */
  84
  85enum CLOCK_sources {
  86        CLK_DPLL,       /* normal halfduplex operation */
  87        CLK_EXTERNAL,   /* external clocking (G3RUH/DF9IC modems) */
  88        CLK_DIVIDER,    /* Rx = DPLL, Tx = divider (fullduplex with */
  89                        /* modems without clock regeneration */
  90        CLK_BRG         /* experimental fullduplex mode with DPLL/BRG for */
  91                        /* MODEMs without clock recovery */
  92};
  93
  94/* Tx state */
  95
  96enum TX_state {
  97        TXS_IDLE,       /* Transmitter off, no data pending */
  98        TXS_BUSY,       /* waiting for permission to send / tailtime */
  99        TXS_ACTIVE,     /* Transmitter on, sending data */
 100        TXS_NEWFRAME,   /* reset CRC and send (next) frame */
 101        TXS_IDLE2,      /* Transmitter on, no data pending */
 102        TXS_WAIT,       /* Waiting for Mintime to expire */
 103        TXS_TIMEOUT     /* We had a transmission timeout */
 104};
 105
 106typedef unsigned long io_port;  /* type definition for an 'io port address' */
 107
 108/* SCC statistical information */
 109
 110struct scc_stat {
 111        long rxints;            /* Receiver interrupts */
 112        long txints;            /* Transmitter interrupts */
 113        long exints;            /* External/status interrupts */
 114        long spints;            /* Special receiver interrupts */
 115
 116        long txframes;          /* Packets sent */
 117        long rxframes;          /* Number of Frames Actually Received */
 118        long rxerrs;            /* CRC Errors */
 119        long txerrs;            /* KISS errors */
 120        
 121        unsigned int nospace;   /* "Out of buffers" */
 122        unsigned int rx_over;   /* Receiver Overruns */
 123        unsigned int tx_under;  /* Transmitter Underruns */
 124
 125        unsigned int tx_state;  /* Transmitter state */
 126        int tx_queued;          /* tx frames enqueued */
 127
 128        unsigned int maxqueue;  /* allocated tx_buffers */
 129        unsigned int bufsize;   /* used buffersize */
 130};
 131
 132struct scc_modem {
 133        long speed;             /* Line speed, bps */
 134        char clocksrc;          /* 0 = DPLL, 1 = external, 2 = divider */
 135        char nrz;               /* NRZ instead of NRZI */       
 136};
 137
 138struct scc_kiss_cmd {
 139        int      command;       /* one of the KISS-Commands defined above */
 140        unsigned param;         /* KISS-Param */
 141};
 142
 143struct scc_hw_config {
 144        io_port data_a;         /* data port channel A */
 145        io_port ctrl_a;         /* control port channel A */
 146        io_port data_b;         /* data port channel B */
 147        io_port ctrl_b;         /* control port channel B */
 148        io_port vector_latch;   /* INTACK-Latch (#) */
 149        io_port special;        /* special function port */
 150
 151        int     irq;            /* irq */
 152        long    clock;          /* clock */
 153        char    option;         /* command for function port */
 154
 155        char brand;             /* hardware type */
 156        char escc;              /* use ext. features of a 8580/85180/85280 */
 157};
 158
 159/* (#) only one INTACK latch allowed. */
 160
 161
 162struct scc_mem_config {
 163        unsigned int dummy;
 164        unsigned int bufsize;
 165};
 166
 167struct scc_calibrate {
 168        unsigned int time;
 169        unsigned char pattern;
 170};
 171
 172#endif /* _UAPI_SCC_H */
 173