linux/include/linux/stmmac.h
<<
>>
Prefs
   1/*******************************************************************************
   2
   3  Header file for stmmac platform data
   4
   5  Copyright (C) 2009  STMicroelectronics Ltd
   6
   7  This program is free software; you can redistribute it and/or modify it
   8  under the terms and conditions of the GNU General Public License,
   9  version 2, as published by the Free Software Foundation.
  10
  11  This program is distributed in the hope it will be useful, but WITHOUT
  12  ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
  13  FITNESS FOR A PARTICULAR PURPOSE.  See the GNU General Public License for
  14  more details.
  15
  16  You should have received a copy of the GNU General Public License along with
  17  this program; if not, write to the Free Software Foundation, Inc.,
  18  51 Franklin St - Fifth Floor, Boston, MA 02110-1301 USA.
  19
  20  The full GNU General Public License is included in this distribution in
  21  the file called "COPYING".
  22
  23  Author: Giuseppe Cavallaro <peppe.cavallaro@st.com>
  24*******************************************************************************/
  25
  26#ifndef __STMMAC_PLATFORM_DATA
  27#define __STMMAC_PLATFORM_DATA
  28
  29#include <linux/platform_device.h>
  30
  31#define STMMAC_RX_COE_NONE      0
  32#define STMMAC_RX_COE_TYPE1     1
  33#define STMMAC_RX_COE_TYPE2     2
  34
  35/* Define the macros for CSR clock range parameters to be passed by
  36 * platform code.
  37 * This could also be configured at run time using CPU freq framework. */
  38
  39/* MDC Clock Selection define*/
  40#define STMMAC_CSR_60_100M      0x0     /* MDC = clk_scr_i/42 */
  41#define STMMAC_CSR_100_150M     0x1     /* MDC = clk_scr_i/62 */
  42#define STMMAC_CSR_20_35M       0x2     /* MDC = clk_scr_i/16 */
  43#define STMMAC_CSR_35_60M       0x3     /* MDC = clk_scr_i/26 */
  44#define STMMAC_CSR_150_250M     0x4     /* MDC = clk_scr_i/102 */
  45#define STMMAC_CSR_250_300M     0x5     /* MDC = clk_scr_i/122 */
  46
  47/* The MDC clock could be set higher than the IEEE 802.3
  48 * specified frequency limit 0f 2.5 MHz, by programming a clock divider
  49 * of value different than the above defined values. The resultant MDIO
  50 * clock frequency of 12.5 MHz is applicable for the interfacing chips
  51 * supporting higher MDC clocks.
  52 * The MDC clock selection macros need to be defined for MDC clock rate
  53 * of 12.5 MHz, corresponding to the following selection.
  54 */
  55#define STMMAC_CSR_I_4          0x8     /* clk_csr_i/4 */
  56#define STMMAC_CSR_I_6          0x9     /* clk_csr_i/6 */
  57#define STMMAC_CSR_I_8          0xA     /* clk_csr_i/8 */
  58#define STMMAC_CSR_I_10         0xB     /* clk_csr_i/10 */
  59#define STMMAC_CSR_I_12         0xC     /* clk_csr_i/12 */
  60#define STMMAC_CSR_I_14         0xD     /* clk_csr_i/14 */
  61#define STMMAC_CSR_I_16         0xE     /* clk_csr_i/16 */
  62#define STMMAC_CSR_I_18         0xF     /* clk_csr_i/18 */
  63
  64/* AXI DMA Burst length supported */
  65#define DMA_AXI_BLEN_4          (1 << 1)
  66#define DMA_AXI_BLEN_8          (1 << 2)
  67#define DMA_AXI_BLEN_16         (1 << 3)
  68#define DMA_AXI_BLEN_32         (1 << 4)
  69#define DMA_AXI_BLEN_64         (1 << 5)
  70#define DMA_AXI_BLEN_128        (1 << 6)
  71#define DMA_AXI_BLEN_256        (1 << 7)
  72#define DMA_AXI_BLEN_ALL (DMA_AXI_BLEN_4 | DMA_AXI_BLEN_8 | DMA_AXI_BLEN_16 \
  73                        | DMA_AXI_BLEN_32 | DMA_AXI_BLEN_64 \
  74                        | DMA_AXI_BLEN_128 | DMA_AXI_BLEN_256)
  75
  76/* Platfrom data for platform device structure's platform_data field */
  77
  78struct stmmac_mdio_bus_data {
  79        int (*phy_reset)(void *priv);
  80        unsigned int phy_mask;
  81        int *irqs;
  82        int probed_phy_irq;
  83#ifdef CONFIG_OF
  84        int reset_gpio, active_low;
  85        u32 delays[3];
  86#endif
  87};
  88
  89struct stmmac_dma_cfg {
  90        int pbl;
  91        int fixed_burst;
  92        int mixed_burst;
  93        int burst_len;
  94};
  95
  96struct plat_stmmacenet_data {
  97        char *phy_bus_name;
  98        int bus_id;
  99        int phy_addr;
 100        int interface;
 101        struct stmmac_mdio_bus_data *mdio_bus_data;
 102        struct stmmac_dma_cfg *dma_cfg;
 103        int clk_csr;
 104        int has_gmac;
 105        int enh_desc;
 106        int tx_coe;
 107        int rx_coe;
 108        int bugged_jumbo;
 109        int pmt;
 110        int force_sf_dma_mode;
 111        int force_thresh_dma_mode;
 112        int riwt_off;
 113        int max_speed;
 114        int maxmtu;
 115        int multicast_filter_bins;
 116        int unicast_filter_entries;
 117        int tx_fifo_size;
 118        int rx_fifo_size;
 119        void (*fix_mac_speed)(void *priv, unsigned int speed);
 120        void (*bus_setup)(void __iomem *ioaddr);
 121        void *(*setup)(struct platform_device *pdev);
 122        void (*free)(struct platform_device *pdev, void *priv);
 123        int (*init)(struct platform_device *pdev, void *priv);
 124        void (*exit)(struct platform_device *pdev, void *priv);
 125        void *custom_cfg;
 126        void *custom_data;
 127        void *bsp_priv;
 128};
 129
 130/* of_data for SoC glue layer device tree bindings */
 131
 132struct stmmac_of_data {
 133        int has_gmac;
 134        int enh_desc;
 135        int tx_coe;
 136        int rx_coe;
 137        int bugged_jumbo;
 138        int pmt;
 139        int riwt_off;
 140        void (*fix_mac_speed)(void *priv, unsigned int speed);
 141        void (*bus_setup)(void __iomem *ioaddr);
 142        void *(*setup)(struct platform_device *pdev);
 143        void (*free)(struct platform_device *pdev, void *priv);
 144        int (*init)(struct platform_device *pdev, void *priv);
 145        void (*exit)(struct platform_device *pdev, void *priv);
 146};
 147#endif
 148