1/****************************************************************************** 2 * 3 * Copyright(c) 2007 - 2010 Realtek Corporation. All rights reserved. 4 * 5 * This program is free software; you can redistribute it and/or modify it 6 * under the terms of version 2 of the GNU General Public License as 7 * published by the Free Software Foundation. 8 * 9 * This program is distributed in the hope that it will be useful, but WITHOUT 10 * ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or 11 * FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for 12 * more details. 13 * 14 * You should have received a copy of the GNU General Public License along with 15 * this program; if not, write to the Free Software Foundation, Inc., 16 * 51 Franklin Street, Fifth Floor, Boston, MA 02110, USA 17 * 18 * Modifications for inclusion into the Linux staging tree are 19 * Copyright(c) 2010 Larry Finger. All rights reserved. 20 * 21 * Contact information: 22 * WLAN FAE <wlanfae@realtek.com> 23 * Larry Finger <Larry.Finger@lwfinger.net> 24 * 25 ******************************************************************************/ 26#ifndef __RTL8712_GP_BITDEF_H__ 27#define __RTL8712_GP_BITDEF_H__ 28 29/*GPIO_CTRL*/ 30#define _GPIO_MOD_MSK 0xFF000000 31#define _GPIO_MOD_SHT 24 32#define _GPIO_IO_SEL_MSK 0x00FF0000 33#define _GPIO_IO_SEL_SHT 16 34#define _GPIO_OUT_MSK 0x0000FF00 35#define _GPIO_OUT_SHT 8 36#define _GPIO_IN_MSK 0x000000FF 37#define _GPIO_IN_SHT 0 38 39/*SYS_PINMUX_CFG*/ 40#define _GPIOSEL_MSK 0x0003 41#define _GPIOSEL_SHT 0 42 43/*LED_CFG*/ 44#define _LED1SV BIT(7) 45#define _LED1CM_MSK 0x0070 46#define _LED1CM_SHT 4 47#define _LED0SV BIT(3) 48#define _LED0CM_MSK 0x0007 49#define _LED0CM_SHT 0 50 51/*PHY_REG*/ 52#define _HST_RDRDY_SHT 0 53#define _HST_RDRDY_MSK 0xFF 54#define _HST_RDRDY BIT(_HST_RDRDY_SHT) 55#define _CPU_WTBUSY_SHT 1 56#define _CPU_WTBUSY_MSK 0xFF 57#define _CPU_WTBUSY BIT(_CPU_WTBUSY_SHT) 58 59/* 11. General Purpose Registers (Offset: 0x02E0 - 0x02FF)*/ 60 61/* 8192S GPIO Config Setting (offset 0x2F1, 1 byte)*/ 62 63/*----------------------------------------------------------------------------*/ 64 65#define GPIOMUX_EN BIT(3) /* When this bit is set to "1", 66 * GPIO PINs will switch to MAC 67 * GPIO Function 68 */ 69#define GPIOSEL_GPIO 0 /* UART or JTAG or pure GPIO*/ 70#define GPIOSEL_PHYDBG 1 /* PHYDBG*/ 71#define GPIOSEL_BT 2 /* BT_coex*/ 72#define GPIOSEL_WLANDBG 3 /* WLANDBG*/ 73#define GPIOSEL_GPIO_MASK (~(BIT(0)|BIT(1))) 74/* HW Radio OFF switch (GPIO BIT) */ 75#define HAL_8192S_HW_GPIO_OFF_BIT BIT(3) 76#define HAL_8192S_HW_GPIO_OFF_MASK 0xF7 77#define HAL_8192S_HW_GPIO_WPS_BIT BIT(4) 78 79#endif /*__RTL8712_GP_BITDEF_H__*/ 80 81