1
2
3
4
5
6
7
8
9#include <linux/module.h>
10#include <linux/bitfield.h>
11#include <linux/ulpi/driver.h>
12#include <linux/ulpi/regs.h>
13#include <linux/gpio/consumer.h>
14#include <linux/phy/ulpi_phy.h>
15
16#define TUSB1210_VENDOR_SPECIFIC2 0x80
17#define TUSB1210_VENDOR_SPECIFIC2_IHSTX_MASK GENMASK(3, 0)
18#define TUSB1210_VENDOR_SPECIFIC2_ZHSDRV_MASK GENMASK(5, 4)
19#define TUSB1210_VENDOR_SPECIFIC2_DP_MASK BIT(6)
20
21struct tusb1210 {
22 struct ulpi *ulpi;
23 struct phy *phy;
24 struct gpio_desc *gpio_reset;
25 struct gpio_desc *gpio_cs;
26 u8 vendor_specific2;
27};
28
29static int tusb1210_power_on(struct phy *phy)
30{
31 struct tusb1210 *tusb = phy_get_drvdata(phy);
32
33 gpiod_set_value_cansleep(tusb->gpio_reset, 1);
34 gpiod_set_value_cansleep(tusb->gpio_cs, 1);
35
36
37 if (tusb->vendor_specific2)
38 ulpi_write(tusb->ulpi, TUSB1210_VENDOR_SPECIFIC2,
39 tusb->vendor_specific2);
40
41 return 0;
42}
43
44static int tusb1210_power_off(struct phy *phy)
45{
46 struct tusb1210 *tusb = phy_get_drvdata(phy);
47
48 gpiod_set_value_cansleep(tusb->gpio_reset, 0);
49 gpiod_set_value_cansleep(tusb->gpio_cs, 0);
50
51 return 0;
52}
53
54static int tusb1210_set_mode(struct phy *phy, enum phy_mode mode, int submode)
55{
56 struct tusb1210 *tusb = phy_get_drvdata(phy);
57 int ret;
58
59 ret = ulpi_read(tusb->ulpi, ULPI_OTG_CTRL);
60 if (ret < 0)
61 return ret;
62
63 switch (mode) {
64 case PHY_MODE_USB_HOST:
65 ret |= (ULPI_OTG_CTRL_DRVVBUS_EXT
66 | ULPI_OTG_CTRL_ID_PULLUP
67 | ULPI_OTG_CTRL_DP_PULLDOWN
68 | ULPI_OTG_CTRL_DM_PULLDOWN);
69 ulpi_write(tusb->ulpi, ULPI_OTG_CTRL, ret);
70 ret |= ULPI_OTG_CTRL_DRVVBUS;
71 break;
72 case PHY_MODE_USB_DEVICE:
73 ret &= ~(ULPI_OTG_CTRL_DRVVBUS
74 | ULPI_OTG_CTRL_DP_PULLDOWN
75 | ULPI_OTG_CTRL_DM_PULLDOWN);
76 ulpi_write(tusb->ulpi, ULPI_OTG_CTRL, ret);
77 ret &= ~ULPI_OTG_CTRL_DRVVBUS_EXT;
78 break;
79 default:
80
81 return 0;
82 }
83
84 return ulpi_write(tusb->ulpi, ULPI_OTG_CTRL, ret);
85}
86
87static const struct phy_ops phy_ops = {
88 .power_on = tusb1210_power_on,
89 .power_off = tusb1210_power_off,
90 .set_mode = tusb1210_set_mode,
91 .owner = THIS_MODULE,
92};
93
94static int tusb1210_probe(struct ulpi *ulpi)
95{
96 struct tusb1210 *tusb;
97 u8 val, reg;
98
99 tusb = devm_kzalloc(&ulpi->dev, sizeof(*tusb), GFP_KERNEL);
100 if (!tusb)
101 return -ENOMEM;
102
103 tusb->gpio_reset = devm_gpiod_get_optional(&ulpi->dev, "reset",
104 GPIOD_OUT_LOW);
105 if (IS_ERR(tusb->gpio_reset))
106 return PTR_ERR(tusb->gpio_reset);
107
108 gpiod_set_value_cansleep(tusb->gpio_reset, 1);
109
110 tusb->gpio_cs = devm_gpiod_get_optional(&ulpi->dev, "cs",
111 GPIOD_OUT_LOW);
112 if (IS_ERR(tusb->gpio_cs))
113 return PTR_ERR(tusb->gpio_cs);
114
115 gpiod_set_value_cansleep(tusb->gpio_cs, 1);
116
117
118
119
120
121
122 reg = ulpi_read(ulpi, TUSB1210_VENDOR_SPECIFIC2);
123
124
125 if (!device_property_read_u8(&ulpi->dev, "ihstx", &val))
126 u8p_replace_bits(®, val, (u8)TUSB1210_VENDOR_SPECIFIC2_IHSTX_MASK);
127
128
129 if (!device_property_read_u8(&ulpi->dev, "zhsdrv", &val))
130 u8p_replace_bits(®, val, (u8)TUSB1210_VENDOR_SPECIFIC2_ZHSDRV_MASK);
131
132
133 if (!device_property_read_u8(&ulpi->dev, "datapolarity", &val))
134 u8p_replace_bits(®, val, (u8)TUSB1210_VENDOR_SPECIFIC2_DP_MASK);
135
136 ulpi_write(ulpi, TUSB1210_VENDOR_SPECIFIC2, reg);
137 tusb->vendor_specific2 = reg;
138
139 tusb->phy = ulpi_phy_create(ulpi, &phy_ops);
140 if (IS_ERR(tusb->phy))
141 return PTR_ERR(tusb->phy);
142
143 tusb->ulpi = ulpi;
144
145 phy_set_drvdata(tusb->phy, tusb);
146 ulpi_set_drvdata(ulpi, tusb);
147 return 0;
148}
149
150static void tusb1210_remove(struct ulpi *ulpi)
151{
152 struct tusb1210 *tusb = ulpi_get_drvdata(ulpi);
153
154 ulpi_phy_destroy(ulpi, tusb->phy);
155}
156
157#define TI_VENDOR_ID 0x0451
158
159static const struct ulpi_device_id tusb1210_ulpi_id[] = {
160 { TI_VENDOR_ID, 0x1507, },
161 { TI_VENDOR_ID, 0x1508, },
162 { },
163};
164MODULE_DEVICE_TABLE(ulpi, tusb1210_ulpi_id);
165
166static struct ulpi_driver tusb1210_driver = {
167 .id_table = tusb1210_ulpi_id,
168 .probe = tusb1210_probe,
169 .remove = tusb1210_remove,
170 .driver = {
171 .name = "tusb1210",
172 .owner = THIS_MODULE,
173 },
174};
175
176module_ulpi_driver(tusb1210_driver);
177
178MODULE_AUTHOR("Intel Corporation");
179MODULE_LICENSE("GPL v2");
180MODULE_DESCRIPTION("TUSB1210 ULPI PHY driver");
181