// SPDX-License-Identifier: GPL-2.0-only
/*
 * Copyright (C) 2014 Synopsys, Inc. (www.synopsys.com)
 */

#include <linux/interrupt.h>
#include <linux/module.h>
#include <linux/of.h>
#include <linux/irqdomain.h>
#include <linux/irqchip.h>
#include <asm/irq.h>

#define NR_EXCEPTIONS   16

struct bcr_irq_arcv2 {
#ifdef CONFIG_CPU_BIG_ENDIAN
        unsigned int pad:3, firq:1, prio:4, exts:8, irqs:8, ver:8;
#else
        unsigned int ver:8, irqs:8, exts:8, prio:4, firq:1, pad:3;
#endif
};

/*
 * Early Hardware specific Interrupt setup
 * -Called very early (start_kernel -> setup_arch -> setup_processor)
 * -Platform Independent (must for any ARC Core)
 * -Needed for each CPU (hence not foldable into init_IRQ)
 */
void arc_init_IRQ(void)
{
        unsigned int tmp, irq_prio, i;
        struct bcr_irq_arcv2 irq_bcr;

        struct aux_irq_ctrl {
#ifdef CONFIG_CPU_BIG_ENDIAN
                unsigned int res3:18, save_idx_regs:1, res2:1,
                             save_u_to_u:1, save_lp_regs:1, save_blink:1,
                             res:4, save_nr_gpr_pairs:5;
#else
                unsigned int save_nr_gpr_pairs:5, res:4,
                             save_blink:1, save_lp_regs:1, save_u_to_u:1,
                             res2:1, save_idx_regs:1, res3:18;
#endif
        } ictrl;

        *(unsigned int *)&ictrl = 0;

#ifndef CONFIG_ARC_IRQ_NO_AUTOSAVE
        ictrl.save_nr_gpr_pairs = 6;    /* r0 to r11 (r12 saved manually) */
        ictrl.save_blink = 1;
        ictrl.save_lp_regs = 1;         /* LP_COUNT, LP_START, LP_END */
        ictrl.save_u_to_u = 0;          /* user ctxt saved on kernel stack */
        ictrl.save_idx_regs = 1;        /* JLI, LDI, EI */
#endif

        WRITE_AUX(AUX_IRQ_CTRL, ictrl);

        /*
         * ARCv2 core intc provides multiple interrupt priorities (upto 16).
         * Typical builds though have only two levels (0-high, 1-low)
         * Linux by default uses lower prio 1 for most irqs, reserving 0 for
         * NMI style interrupts in future (say perf)
         */

        READ_BCR(ARC_REG_IRQ_BCR, irq_bcr);

        irq_prio = irq_bcr.prio;        /* Encoded as N-1 for N levels */
        pr_info("archs-intc\t: %d priority levels (default %d)%s\n",
                irq_prio + 1, ARCV2_IRQ_DEF_PRIO,
                irq_bcr.firq ? " FIRQ (not used)":"");

        /*
         * Set a default priority for all available interrupts to prevent
         * switching of register banks if Fast IRQ and multiple register banks
         * are supported by CPU.
         * Also disable private-per-core IRQ lines so faulty external HW won't
         * trigger interrupt that kernel is not ready to handle.
         */
        for (i = NR_EXCEPTIONS; i < irq_bcr.irqs + NR_EXCEPTIONS; i++) {
                write_aux_reg(AUX_IRQ_SELECT, i);
                write_aux_reg(AUX_IRQ_PRIORITY, ARCV2_IRQ_DEF_PRIO);

                /*
                 * Only mask cpu private IRQs here.
                 * "common" interrupts are masked at IDU, otherwise it would
                 * need to be unmasked at each cpu, with IPIs
                 */
                if (i < FIRST_EXT_IRQ)
                        write_aux_reg(AUX_IRQ_ENABLE, 0);
        }

        /* setup status32, don't enable intr yet as kernel doesn't want */
        tmp = read_aux_reg(ARC_REG_STATUS32);
        tmp |= ARCV2_IRQ_DEF_PRIO << 1;
        tmp &= ~STATUS_IE_MASK;
        asm volatile("kflag %0  \n"::"r"(tmp));
}

static void arcv2_irq_mask(struct irq_data *data)
{
        write_aux_reg(AUX_IRQ_SELECT, data->hwirq);
        write_aux_reg(AUX_IRQ_ENABLE, 0);
}

static void arcv2_irq_unmask(struct irq_data *data)
{
        write_aux_reg(AUX_IRQ_SELECT, data->hwirq);
        write_aux_reg(AUX_IRQ_ENABLE, 1);
}

void arcv2_irq_enable(struct irq_data *data)
{
        /* set default priority */
        write_aux_reg(AUX_IRQ_SELECT, data->hwirq);
        write_aux_reg(AUX_IRQ_PRIORITY, ARCV2_IRQ_DEF_PRIO);

        /*
         * hw auto enables (linux unmask) all by default
         * So no need to do IRQ_ENABLE here
         * XXX: However OSCI LAN need it
         */
        write_aux_reg(AUX_IRQ_ENABLE, 1);
}

static struct irq_chip arcv2_irq_chip = {
        .name           = "ARCv2 core Intc",
        .irq_mask       = arcv2_irq_mask,
        .irq_unmask     = arcv2_irq_unmask,
        .irq_enable     = arcv2_irq_enable
};

static int arcv2_irq_map(struct irq_domain *d, unsigned int irq,
                         irq_hw_number_t hw)
{
        /*
         * core intc IRQs [16, 23]:
         * Statically assigned always private-per-core (Timers, WDT, IPI, PCT)
         */
        if (hw < FIRST_EXT_IRQ) {
                /*
                 * A subsequent request_percpu_irq() fails if percpu_devid is
                 * not set. That in turns sets NOAUTOEN, meaning each core needs
                 * to call enable_percpu_irq()
                 */
                irq_set_percpu_devid(irq);
                irq_set_chip_and_handler(irq, &arcv2_irq_chip, handle_percpu_irq);
        } else {
                irq_set_chip_and_handler(irq, &arcv2_irq_chip, handle_level_irq);
        }

        return 0;
}

static const struct irq_domain_ops arcv2_irq_ops = {
        .xlate = irq_domain_xlate_onecell,
        .map = arcv2_irq_map,
};


static int __init
init_onchip_IRQ(struct device_node *intc, struct device_node *parent)
{
        struct irq_domain *root_domain;
        struct bcr_irq_arcv2 irq_bcr;
        unsigned int nr_cpu_irqs;

        READ_BCR(ARC_REG_IRQ_BCR, irq_bcr);
        nr_cpu_irqs = irq_bcr.irqs + NR_EXCEPTIONS;

        if (parent)
                panic("DeviceTree incore intc not a root irq controller\n");

        root_domain = irq_domain_add_linear(intc, nr_cpu_irqs, &arcv2_irq_ops, NULL);
        if (!root_domain)
                panic("root irq domain not avail\n");

        /*
         * Needed for primary domain lookup to succeed
         * This is a primary irqchip, and can never have a parent
         */
        irq_set_default_host(root_domain);

#ifdef CONFIG_SMP
        irq_create_mapping(root_domain, IPI_IRQ);
#endif
        irq_create_mapping(root_domain, SOFTIRQ_IRQ);

        return 0;
}

IRQCHIP_DECLARE(arc_intc, "snps,archs-intc", init_onchip_IRQ);