1/* SPDX-License-Identifier: GPL-2.0-or-later */ 2/****************************************************************** 3 * Copyright (c) 2000-2007 PMC-Sierra INC. 4 * 5 * PMC-SIERRA INC. DISCLAIMS ANY LIABILITY OF ANY KIND 6 * FOR ANY DAMAGES WHATSOEVER RESULTING FROM THE USE OF THIS 7 * SOFTWARE. 8 */ 9#ifndef MSP_USB_H_ 10#define MSP_USB_H_ 11 12#define NUM_USB_DEVS 1 13 14/* Register spaces for USB host 0 */ 15#define MSP_USB0_MAB_START (MSP_USB0_BASE + 0x0) 16#define MSP_USB0_MAB_END (MSP_USB0_BASE + 0x17) 17#define MSP_USB0_ID_START (MSP_USB0_BASE + 0x40000) 18#define MSP_USB0_ID_END (MSP_USB0_BASE + 0x4008f) 19#define MSP_USB0_HS_START (MSP_USB0_BASE + 0x40100) 20#define MSP_USB0_HS_END (MSP_USB0_BASE + 0x401FF) 21 22/* Register spaces for USB host 1 */ 23#define MSP_USB1_MAB_START (MSP_USB1_BASE + 0x0) 24#define MSP_USB1_MAB_END (MSP_USB1_BASE + 0x17) 25#define MSP_USB1_ID_START (MSP_USB1_BASE + 0x40000) 26#define MSP_USB1_ID_END (MSP_USB1_BASE + 0x4008f) 27#define MSP_USB1_HS_START (MSP_USB1_BASE + 0x40100) 28#define MSP_USB1_HS_END (MSP_USB1_BASE + 0x401ff) 29 30/* USB Identification registers */ 31struct msp_usbid_regs { 32 u32 id; /* 0x0: Identification register */ 33 u32 hwgen; /* 0x4: General HW params */ 34 u32 hwhost; /* 0x8: Host HW params */ 35 u32 hwdev; /* 0xc: Device HW params */ 36 u32 hwtxbuf; /* 0x10: Tx buffer HW params */ 37 u32 hwrxbuf; /* 0x14: Rx buffer HW params */ 38 u32 reserved[26]; 39 u32 timer0_load; /* 0x80: General-purpose timer 0 load*/ 40 u32 timer0_ctrl; /* 0x84: General-purpose timer 0 control */ 41 u32 timer1_load; /* 0x88: General-purpose timer 1 load*/ 42 u32 timer1_ctrl; /* 0x8c: General-purpose timer 1 control */ 43}; 44 45/* MSBus to AMBA registers */ 46struct msp_mab_regs { 47 u32 isr; /* 0x0: Interrupt status */ 48 u32 imr; /* 0x4: Interrupt mask */ 49 u32 thcr0; /* 0x8: Transaction header capture 0 */ 50 u32 thcr1; /* 0xc: Transaction header capture 1 */ 51 u32 int_stat; /* 0x10: Interrupt status summary */ 52 u32 phy_cfg; /* 0x14: USB phy config */ 53}; 54 55/* EHCI registers */ 56struct msp_usbhs_regs { 57 u32 hciver; /* 0x0: Version and offset to operational regs */ 58 u32 hcsparams; /* 0x4: Host control structural parameters */ 59 u32 hccparams; /* 0x8: Host control capability parameters */ 60 u32 reserved0[5]; 61 u32 dciver; /* 0x20: Device interface version */ 62 u32 dccparams; /* 0x24: Device control capability parameters */ 63 u32 reserved1[6]; 64 u32 cmd; /* 0x40: USB command */ 65 u32 sts; /* 0x44: USB status */ 66 u32 int_ena; /* 0x48: USB interrupt enable */ 67 u32 frindex; /* 0x4c: Frame index */ 68 u32 reserved3; 69 union { 70 struct { 71 u32 flb_addr; /* 0x54: Frame list base address */ 72 u32 next_async_addr; /* 0x58: next asynchronous addr */ 73 u32 ttctrl; /* 0x5c: embedded transaction translator 74 async buffer status */ 75 u32 burst_size; /* 0x60: Controller burst size */ 76 u32 tx_fifo_ctrl; /* 0x64: Tx latency FIFO tuning */ 77 u32 reserved0[4]; 78 u32 endpt_nak; /* 0x78: Endpoint NAK */ 79 u32 endpt_nak_ena; /* 0x7c: Endpoint NAK enable */ 80 u32 cfg_flag; /* 0x80: Config flag */ 81 u32 port_sc1; /* 0x84: Port status & control 1 */ 82 u32 reserved1[7]; 83 u32 otgsc; /* 0xa4: OTG status & control */ 84 u32 mode; /* 0xa8: USB controller mode */ 85 } host; 86 87 struct { 88 u32 dev_addr; /* 0x54: Device address */ 89 u32 endpt_list_addr; /* 0x58: Endpoint list address */ 90 u32 reserved0[7]; 91 u32 endpt_nak; /* 0x74 */ 92 u32 endpt_nak_ctrl; /* 0x78 */ 93 u32 cfg_flag; /* 0x80 */ 94 u32 port_sc1; /* 0x84: Port status & control 1 */ 95 u32 reserved[7]; 96 u32 otgsc; /* 0xa4: OTG status & control */ 97 u32 mode; /* 0xa8: USB controller mode */ 98 u32 endpt_setup_stat; /* 0xac */ 99 u32 endpt_prime; /* 0xb0 */ 100 u32 endpt_flush; /* 0xb4 */ 101 u32 endpt_stat; /* 0xb8 */ 102 u32 endpt_complete; /* 0xbc */ 103 u32 endpt_ctrl0; /* 0xc0 */ 104 u32 endpt_ctrl1; /* 0xc4 */ 105 u32 endpt_ctrl2; /* 0xc8 */ 106 u32 endpt_ctrl3; /* 0xcc */ 107 } device; 108 } u; 109}; 110/* 111 * Container for the more-generic platform_device. 112 * This exists mainly as a way to map the non-standard register 113 * spaces and make them accessible to the USB ISR. 114 */ 115struct mspusb_device { 116 struct msp_mab_regs __iomem *mab_regs; 117 struct msp_usbid_regs __iomem *usbid_regs; 118 struct msp_usbhs_regs __iomem *usbhs_regs; 119 struct platform_device dev; 120}; 121 122#define to_mspusb_device(x) container_of((x), struct mspusb_device, dev) 123#define TO_HOST_ID(x) ((x) & 0x3) 124#endif /*MSP_USB_H_*/ 125