LXR linux/drivers/pci/Makefile

   1# SPDX-License-Identifier: GPL-2.0
   2#
   3# Makefile for the PCI bus specific drivers.
   4
   5obj-$(CONFIG_PCI)               += access.o bus.o probe.o host-bridge.o \
   6                                   remove.o pci.o pci-driver.o search.o \
   7                                   pci-sysfs.o rom.o setup-res.o irq.o vpd.o \
   8                                   setup-bus.o vc.o mmap.o setup-irq.o
   9
  10obj-$(CONFIG_PCI)               += pcie/
  11
  12ifdef CONFIG_PCI
  13obj-$(CONFIG_PROC_FS)           += proc.o
  14obj-$(CONFIG_SYSFS)             += slot.o
  15obj-$(CONFIG_ACPI)              += pci-acpi.o
  16endif
  17
  18obj-$(CONFIG_OF)                += of.o
  19obj-$(CONFIG_PCI_QUIRKS)        += quirks.o
  20obj-$(CONFIG_HOTPLUG_PCI)       += hotplug/
  21obj-$(CONFIG_PCI_MSI)           += msi.o
  22obj-$(CONFIG_PCI_ATS)           += ats.o
  23obj-$(CONFIG_PCI_IOV)           += iov.o
  24obj-$(CONFIG_PCI_BRIDGE_EMUL)   += pci-bridge-emul.o
  25obj-$(CONFIG_PCI_LABEL)         += pci-label.o
  26obj-$(CONFIG_X86_INTEL_MID)     += pci-mid.o
  27obj-$(CONFIG_PCI_SYSCALL)       += syscall.o
  28obj-$(CONFIG_PCI_STUB)          += pci-stub.o
  29obj-$(CONFIG_PCI_PF_STUB)       += pci-pf-stub.o
  30obj-$(CONFIG_PCI_ECAM)          += ecam.o
  31obj-$(CONFIG_PCI_P2PDMA)        += p2pdma.o
  32obj-$(CONFIG_XEN_PCIDEV_FRONTEND) += xen-pcifront.o
  33
  34# Endpoint library must be initialized before its users
  35obj-$(CONFIG_PCI_ENDPOINT)      += endpoint/
  36
  37obj-y                           += controller/
  38obj-y                           += switch/
  39
  40ccflags-$(CONFIG_PCI_DEBUG) := -DDEBUG
  41