LXR linux/drivers/net/ethernet/intel/igb/e1000

   1/* Intel(R) Gigabit Ethernet Linux driver
   2 * Copyright(c) 2007-2014 Intel Corporation.
   3 *
   4 * This program is free software; you can redistribute it and/or modify it
   5 * under the terms and conditions of the GNU General Public License,
   6 * version 2, as published by the Free Software Foundation.
   7 *
   8 * This program is distributed in the hope it will be useful, but WITHOUT
   9 * ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
  10 * FITNESS FOR A PARTICULAR PURPOSE.  See the GNU General Public License for
  11 * more details.
  12 *
  13 * You should have received a copy of the GNU General Public License along with
  14 * this program; if not, see <http://www.gnu.org/licenses/>.
  15 *
  16 * The full GNU General Public License is included in this distribution in
  17 * the file called "COPYING".
  18 *
  19 * Contact Information:
  20 * e1000-devel Mailing List <e1000-devel@lists.sourceforge.net>
  21 * Intel Corporation, 5200 N.E. Elam Young Parkway, Hillsboro, OR 97124-6497
  22 */
  23
  24#ifndef _E1000_PHY_H_
  25#define _E1000_PHY_H_
  26
  27enum e1000_ms_type {
  28        e1000_ms_hw_default = 0,
  29        e1000_ms_force_master,
  30        e1000_ms_force_slave,
  31        e1000_ms_auto
  32};
  33
  34enum e1000_smart_speed {
  35        e1000_smart_speed_default = 0,
  36        e1000_smart_speed_on,
  37        e1000_smart_speed_off
  38};
  39
  40s32  igb_check_downshift(struct e1000_hw *hw);
  41s32  igb_check_reset_block(struct e1000_hw *hw);
  42s32  igb_copper_link_setup_igp(struct e1000_hw *hw);
  43s32  igb_copper_link_setup_m88(struct e1000_hw *hw);
  44s32  igb_copper_link_setup_m88_gen2(struct e1000_hw *hw);
  45s32  igb_phy_force_speed_duplex_igp(struct e1000_hw *hw);
  46s32  igb_phy_force_speed_duplex_m88(struct e1000_hw *hw);
  47s32  igb_get_cable_length_m88(struct e1000_hw *hw);
  48s32  igb_get_cable_length_m88_gen2(struct e1000_hw *hw);
  49s32  igb_get_cable_length_igp_2(struct e1000_hw *hw);
  50s32  igb_get_phy_id(struct e1000_hw *hw);
  51s32  igb_get_phy_info_igp(struct e1000_hw *hw);
  52s32  igb_get_phy_info_m88(struct e1000_hw *hw);
  53s32  igb_phy_sw_reset(struct e1000_hw *hw);
  54s32  igb_phy_hw_reset(struct e1000_hw *hw);
  55s32  igb_read_phy_reg_igp(struct e1000_hw *hw, u32 offset, u16 *data);
  56s32  igb_set_d3_lplu_state(struct e1000_hw *hw, bool active);
  57s32  igb_setup_copper_link(struct e1000_hw *hw);
  58s32  igb_write_phy_reg_igp(struct e1000_hw *hw, u32 offset, u16 data);
  59s32  igb_phy_has_link(struct e1000_hw *hw, u32 iterations,
  60                                u32 usec_interval, bool *success);
  61void igb_power_up_phy_copper(struct e1000_hw *hw);
  62void igb_power_down_phy_copper(struct e1000_hw *hw);
  63s32  igb_phy_init_script_igp3(struct e1000_hw *hw);
  64s32  igb_initialize_M88E1512_phy(struct e1000_hw *hw);
  65s32  igb_initialize_M88E1543_phy(struct e1000_hw *hw);
  66s32  igb_read_phy_reg_mdic(struct e1000_hw *hw, u32 offset, u16 *data);
  67s32  igb_write_phy_reg_mdic(struct e1000_hw *hw, u32 offset, u16 data);
  68s32  igb_read_phy_reg_i2c(struct e1000_hw *hw, u32 offset, u16 *data);
  69s32  igb_write_phy_reg_i2c(struct e1000_hw *hw, u32 offset, u16 data);
  70s32  igb_read_sfp_data_byte(struct e1000_hw *hw, u16 offset, u8 *data);
  71s32  igb_copper_link_setup_82580(struct e1000_hw *hw);
  72s32  igb_get_phy_info_82580(struct e1000_hw *hw);
  73s32  igb_phy_force_speed_duplex_82580(struct e1000_hw *hw);
  74s32  igb_get_cable_length_82580(struct e1000_hw *hw);
  75s32  igb_read_phy_reg_82580(struct e1000_hw *hw, u32 offset, u16 *data);
  76s32  igb_write_phy_reg_82580(struct e1000_hw *hw, u32 offset, u16 data);
  77s32  igb_check_polarity_m88(struct e1000_hw *hw);
  78
  79/* IGP01E1000 Specific Registers */
  80#define IGP01E1000_PHY_PORT_CONFIG        0x10 /* Port Config */
  81#define IGP01E1000_PHY_PORT_STATUS        0x11 /* Status */
  82#define IGP01E1000_PHY_PORT_CTRL          0x12 /* Control */
  83#define IGP01E1000_PHY_LINK_HEALTH        0x13 /* PHY Link Health */
  84#define IGP02E1000_PHY_POWER_MGMT         0x19 /* Power Management */
  85#define IGP01E1000_PHY_PAGE_SELECT        0x1F /* Page Select */
  86#define IGP01E1000_PHY_PCS_INIT_REG       0x00B4
  87#define IGP01E1000_PHY_POLARITY_MASK      0x0078
  88#define IGP01E1000_PSCR_AUTO_MDIX         0x1000
  89#define IGP01E1000_PSCR_FORCE_MDI_MDIX    0x2000 /* 0=MDI, 1=MDIX */
  90#define IGP01E1000_PSCFR_SMART_SPEED      0x0080
  91
  92#define I82580_ADDR_REG                   16
  93#define I82580_CFG_REG                    22
  94#define I82580_CFG_ASSERT_CRS_ON_TX       BIT(15)
  95#define I82580_CFG_ENABLE_DOWNSHIFT       (3u << 10) /* auto downshift 100/10 */
  96#define I82580_CTRL_REG                   23
  97#define I82580_CTRL_DOWNSHIFT_MASK        (7u << 10)
  98
  99/* 82580 specific PHY registers */
 100#define I82580_PHY_CTRL_2            18
 101#define I82580_PHY_LBK_CTRL          19
 102#define I82580_PHY_STATUS_2          26
 103#define I82580_PHY_DIAG_STATUS       31
 104
 105/* I82580 PHY Status 2 */
 106#define I82580_PHY_STATUS2_REV_POLARITY   0x0400
 107#define I82580_PHY_STATUS2_MDIX           0x0800
 108#define I82580_PHY_STATUS2_SPEED_MASK     0x0300
 109#define I82580_PHY_STATUS2_SPEED_1000MBPS 0x0200
 110#define I82580_PHY_STATUS2_SPEED_100MBPS  0x0100
 111
 112/* I82580 PHY Control 2 */
 113#define I82580_PHY_CTRL2_MANUAL_MDIX      0x0200
 114#define I82580_PHY_CTRL2_AUTO_MDI_MDIX    0x0400
 115#define I82580_PHY_CTRL2_MDIX_CFG_MASK    0x0600
 116
 117/* I82580 PHY Diagnostics Status */
 118#define I82580_DSTATUS_CABLE_LENGTH       0x03FC
 119#define I82580_DSTATUS_CABLE_LENGTH_SHIFT 2
 120
 121/* 82580 PHY Power Management */
 122#define E1000_82580_PHY_POWER_MGMT      0xE14
 123#define E1000_82580_PM_SPD              0x0001 /* Smart Power Down */
 124#define E1000_82580_PM_D0_LPLU          0x0002 /* For D0a states */
 125#define E1000_82580_PM_D3_LPLU          0x0004 /* For all other states */
 126#define E1000_82580_PM_GO_LINKD         0x0020 /* Go Link Disconnect */
 127
 128/* Enable flexible speed on link-up */
 129#define IGP02E1000_PM_D0_LPLU             0x0002 /* For D0a states */
 130#define IGP02E1000_PM_D3_LPLU             0x0004 /* For all other states */
 131#define IGP01E1000_PLHR_SS_DOWNGRADE      0x8000
 132#define IGP01E1000_PSSR_POLARITY_REVERSED 0x0002
 133#define IGP01E1000_PSSR_MDIX              0x0800
 134#define IGP01E1000_PSSR_SPEED_MASK        0xC000
 135#define IGP01E1000_PSSR_SPEED_1000MBPS    0xC000
 136#define IGP02E1000_PHY_CHANNEL_NUM        4
 137#define IGP02E1000_PHY_AGC_A              0x11B1
 138#define IGP02E1000_PHY_AGC_B              0x12B1
 139#define IGP02E1000_PHY_AGC_C              0x14B1
 140#define IGP02E1000_PHY_AGC_D              0x18B1
 141#define IGP02E1000_AGC_LENGTH_SHIFT       9   /* Course - 15:13, Fine - 12:9 */
 142#define IGP02E1000_AGC_LENGTH_MASK        0x7F
 143#define IGP02E1000_AGC_RANGE              15
 144
 145#define E1000_CABLE_LENGTH_UNDEFINED      0xFF
 146
 147/* SFP modules ID memory locations */
 148#define E1000_SFF_IDENTIFIER_OFFSET     0x00
 149#define E1000_SFF_IDENTIFIER_SFF        0x02
 150#define E1000_SFF_IDENTIFIER_SFP        0x03
 151
 152#define E1000_SFF_ETH_FLAGS_OFFSET      0x06
 153/* Flags for SFP modules compatible with ETH up to 1Gb */
 154struct e1000_sfp_flags {
 155        u8 e1000_base_sx:1;
 156        u8 e1000_base_lx:1;
 157        u8 e1000_base_cx:1;
 158        u8 e1000_base_t:1;
 159        u8 e100_base_lx:1;
 160        u8 e100_base_fx:1;
 161        u8 e10_base_bx10:1;
 162        u8 e10_base_px:1;
 163};
 164
 165#endif
 166