// SPDX-License-Identifier: GPL-2.0-or-later
/*
 *  linux/arch/arm/mach-integrator/integrator_ap.c
 *
 *  Copyright (C) 2000-2003 Deep Blue Solutions Ltd
 */
#include <linux/kernel.h>
#include <linux/init.h>
#include <linux/syscore_ops.h>
#include <linux/amba/bus.h>
#include <linux/io.h>
#include <linux/irqchip.h>
#include <linux/of_irq.h>
#include <linux/of_address.h>
#include <linux/of_platform.h>
#include <linux/termios.h>
#include <linux/mfd/syscon.h>
#include <linux/regmap.h>

#include <asm/mach/arch.h>
#include <asm/mach/map.h>

#include "hardware.h"
#include "cm.h"
#include "common.h"

/* Regmap to the AP system controller */
static struct regmap *ap_syscon_map;

/*
 * All IO addresses are mapped onto VA 0xFFFx.xxxx, where x.xxxx
 * is the (PA >> 12).
 *
 * Setup a VA for the Integrator interrupt controller (for header #0,
 * just for now).
 */
#define VA_IC_BASE      __io_address(INTEGRATOR_IC_BASE)

/*
 * Logical      Physical
 * f1400000     14000000        Interrupt controller
 * f1600000     16000000        UART 0
 */

static struct map_desc ap_io_desc[] __initdata __maybe_unused = {
        {
                .virtual        = IO_ADDRESS(INTEGRATOR_IC_BASE),
                .pfn            = __phys_to_pfn(INTEGRATOR_IC_BASE),
                .length         = SZ_4K,
                .type           = MT_DEVICE
        }, {
                .virtual        = IO_ADDRESS(INTEGRATOR_UART0_BASE),
                .pfn            = __phys_to_pfn(INTEGRATOR_UART0_BASE),
                .length         = SZ_4K,
                .type           = MT_DEVICE
        }
};

static void __init ap_map_io(void)
{
        iotable_init(ap_io_desc, ARRAY_SIZE(ap_io_desc));
}

#ifdef CONFIG_PM
static unsigned long ic_irq_enable;

static int irq_suspend(void)
{
        ic_irq_enable = readl(VA_IC_BASE + IRQ_ENABLE);
        return 0;
}

static void irq_resume(void)
{
        /* disable all irq sources */
        cm_clear_irqs();
        writel(-1, VA_IC_BASE + IRQ_ENABLE_CLEAR);
        writel(-1, VA_IC_BASE + FIQ_ENABLE_CLEAR);

        writel(ic_irq_enable, VA_IC_BASE + IRQ_ENABLE_SET);
}
#else
#define irq_suspend NULL
#define irq_resume NULL
#endif

static struct syscore_ops irq_syscore_ops = {
        .suspend        = irq_suspend,
        .resume         = irq_resume,
};

static int __init irq_syscore_init(void)
{
        register_syscore_ops(&irq_syscore_ops);

        return 0;
}

device_initcall(irq_syscore_init);

/*
 * For the PL010 found in the Integrator/AP some of the UART control is
 * implemented in the system controller and accessed using a callback
 * from the driver.
 */
static void integrator_uart_set_mctrl(struct amba_device *dev,
                                void __iomem *base, unsigned int mctrl)
{
        unsigned int ctrls = 0, ctrlc = 0, rts_mask, dtr_mask;
        u32 phybase = dev->res.start;
        int ret;

        if (phybase == INTEGRATOR_UART0_BASE) {
                /* UART0 */
                rts_mask = 1 << 4;
                dtr_mask = 1 << 5;
        } else {
                /* UART1 */
                rts_mask = 1 << 6;
                dtr_mask = 1 << 7;
        }

        if (mctrl & TIOCM_RTS)
                ctrlc |= rts_mask;
        else
                ctrls |= rts_mask;

        if (mctrl & TIOCM_DTR)
                ctrlc |= dtr_mask;
        else
                ctrls |= dtr_mask;

        ret = regmap_write(ap_syscon_map,
                           INTEGRATOR_SC_CTRLS_OFFSET,
                           ctrls);
        if (ret)
                pr_err("MODEM: unable to write PL010 UART CTRLS\n");

        ret = regmap_write(ap_syscon_map,
                           INTEGRATOR_SC_CTRLC_OFFSET,
                           ctrlc);
        if (ret)
                pr_err("MODEM: unable to write PL010 UART CRTLC\n");
}

struct amba_pl010_data ap_uart_data = {
        .set_mctrl = integrator_uart_set_mctrl,
};

void __init ap_init_early(void)
{
}

static void __init ap_init_irq_of(void)
{
        cm_init();
        irqchip_init();
}

/* For the Device Tree, add in the UART callbacks as AUXDATA */
static struct of_dev_auxdata ap_auxdata_lookup[] __initdata = {
        OF_DEV_AUXDATA("arm,primecell", INTEGRATOR_UART0_BASE,
                "uart0", &ap_uart_data),
        OF_DEV_AUXDATA("arm,primecell", INTEGRATOR_UART1_BASE,
                "uart1", &ap_uart_data),
        { /* sentinel */ },
};

static const struct of_device_id ap_syscon_match[] = {
        { .compatible = "arm,integrator-ap-syscon"},
        { },
};

static void __init ap_init_of(void)
{
        struct device_node *syscon;

        of_platform_default_populate(NULL, ap_auxdata_lookup, NULL);

        syscon = of_find_matching_node(NULL, ap_syscon_match);
        if (!syscon)
                return;
        ap_syscon_map = syscon_node_to_regmap(syscon);
        if (IS_ERR(ap_syscon_map)) {
                pr_crit("could not find Integrator/AP system controller\n");
                return;
        }
}

static const char * ap_dt_board_compat[] = {
        "arm,integrator-ap",
        NULL,
};

DT_MACHINE_START(INTEGRATOR_AP_DT, "ARM Integrator/AP (Device Tree)")
        .reserve        = integrator_reserve,
        .map_io         = ap_map_io,
        .init_early     = ap_init_early,
        .init_irq       = ap_init_irq_of,
        .init_machine   = ap_init_of,
        .dt_compat      = ap_dt_board_compat,
MACHINE_END