1/* SPDX-License-Identifier: GPL-2.0-or-later */ 2/* 3 * Header file for the Atmel DDR/SDR SDRAM Controller 4 * 5 * Copyright (C) 2010 Atmel Corporation 6 * Nicolas Ferre <nicolas.ferre@atmel.com> 7 */ 8#ifndef AT91SAM9_DDRSDR_H 9#define AT91SAM9_DDRSDR_H 10 11#define AT91_DDRSDRC_MR 0x00 /* Mode Register */ 12#define AT91_DDRSDRC_MODE (0x7 << 0) /* Command Mode */ 13#define AT91_DDRSDRC_MODE_NORMAL 0 14#define AT91_DDRSDRC_MODE_NOP 1 15#define AT91_DDRSDRC_MODE_PRECHARGE 2 16#define AT91_DDRSDRC_MODE_LMR 3 17#define AT91_DDRSDRC_MODE_REFRESH 4 18#define AT91_DDRSDRC_MODE_EXT_LMR 5 19#define AT91_DDRSDRC_MODE_DEEP 6 20 21#define AT91_DDRSDRC_RTR 0x04 /* Refresh Timer Register */ 22#define AT91_DDRSDRC_COUNT (0xfff << 0) /* Refresh Timer Counter */ 23 24#define AT91_DDRSDRC_CR 0x08 /* Configuration Register */ 25#define AT91_DDRSDRC_NC (3 << 0) /* Number of Column Bits */ 26#define AT91_DDRSDRC_NC_SDR8 (0 << 0) 27#define AT91_DDRSDRC_NC_SDR9 (1 << 0) 28#define AT91_DDRSDRC_NC_SDR10 (2 << 0) 29#define AT91_DDRSDRC_NC_SDR11 (3 << 0) 30#define AT91_DDRSDRC_NC_DDR9 (0 << 0) 31#define AT91_DDRSDRC_NC_DDR10 (1 << 0) 32#define AT91_DDRSDRC_NC_DDR11 (2 << 0) 33#define AT91_DDRSDRC_NC_DDR12 (3 << 0) 34#define AT91_DDRSDRC_NR (3 << 2) /* Number of Row Bits */ 35#define AT91_DDRSDRC_NR_11 (0 << 2) 36#define AT91_DDRSDRC_NR_12 (1 << 2) 37#define AT91_DDRSDRC_NR_13 (2 << 2) 38#define AT91_DDRSDRC_NR_14 (3 << 2) 39#define AT91_DDRSDRC_CAS (7 << 4) /* CAS Latency */ 40#define AT91_DDRSDRC_CAS_2 (2 << 4) 41#define AT91_DDRSDRC_CAS_3 (3 << 4) 42#define AT91_DDRSDRC_CAS_25 (6 << 4) 43#define AT91_DDRSDRC_RST_DLL (1 << 7) /* Reset DLL */ 44#define AT91_DDRSDRC_DICDS (1 << 8) /* Output impedance control */ 45#define AT91_DDRSDRC_DIS_DLL (1 << 9) /* Disable DLL [SAM9 Only] */ 46#define AT91_DDRSDRC_OCD (1 << 12) /* Off-Chip Driver [SAM9 Only] */ 47#define AT91_DDRSDRC_DQMS (1 << 16) /* Mask Data is Shared [SAM9 Only] */ 48#define AT91_DDRSDRC_ACTBST (1 << 18) /* Active Bank X to Burst Stop Read Access Bank Y [SAM9 Only] */ 49 50#define AT91_DDRSDRC_T0PR 0x0C /* Timing 0 Register */ 51#define AT91_DDRSDRC_TRAS (0xf << 0) /* Active to Precharge delay */ 52#define AT91_DDRSDRC_TRCD (0xf << 4) /* Row to Column delay */ 53#define AT91_DDRSDRC_TWR (0xf << 8) /* Write recovery delay */ 54#define AT91_DDRSDRC_TRC (0xf << 12) /* Row cycle delay */ 55#define AT91_DDRSDRC_TRP (0xf << 16) /* Row precharge delay */ 56#define AT91_DDRSDRC_TRRD (0xf << 20) /* Active BankA to BankB */ 57#define AT91_DDRSDRC_TWTR (0x7 << 24) /* Internal Write to Read delay */ 58#define AT91_DDRSDRC_RED_WRRD (0x1 << 27) /* Reduce Write to Read Delay [SAM9 Only] */ 59#define AT91_DDRSDRC_TMRD (0xf << 28) /* Load mode to active/refresh delay */ 60 61#define AT91_DDRSDRC_T1PR 0x10 /* Timing 1 Register */ 62#define AT91_DDRSDRC_TRFC (0x1f << 0) /* Row Cycle Delay */ 63#define AT91_DDRSDRC_TXSNR (0xff << 8) /* Exit self-refresh to non-read */ 64#define AT91_DDRSDRC_TXSRD (0xff << 16) /* Exit self-refresh to read */ 65#define AT91_DDRSDRC_TXP (0xf << 24) /* Exit power-down delay */ 66 67#define AT91_DDRSDRC_T2PR 0x14 /* Timing 2 Register [SAM9 Only] */ 68#define AT91_DDRSDRC_TXARD (0xf << 0) /* Exit active power down delay to read command in mode "Fast Exit" */ 69#define AT91_DDRSDRC_TXARDS (0xf << 4) /* Exit active power down delay to read command in mode "Slow Exit" */ 70#define AT91_DDRSDRC_TRPA (0xf << 8) /* Row Precharge All delay */ 71#define AT91_DDRSDRC_TRTP (0x7 << 12) /* Read to Precharge delay */ 72 73#define AT91_DDRSDRC_LPR 0x1C /* Low Power Register */ 74#define AT91_DDRSDRC_LPCB (3 << 0) /* Low-power Configurations */ 75#define AT91_DDRSDRC_LPCB_DISABLE 0 76#define AT91_DDRSDRC_LPCB_SELF_REFRESH 1 77#define AT91_DDRSDRC_LPCB_POWER_DOWN 2 78#define AT91_DDRSDRC_LPCB_DEEP_POWER_DOWN 3 79#define AT91_DDRSDRC_CLKFR (1 << 2) /* Clock Frozen */ 80#define AT91_DDRSDRC_LPDDR2_PWOFF (1 << 3) /* LPDDR Power Off */ 81#define AT91_DDRSDRC_PASR (7 << 4) /* Partial Array Self Refresh */ 82#define AT91_DDRSDRC_TCSR (3 << 8) /* Temperature Compensated Self Refresh */ 83#define AT91_DDRSDRC_DS (3 << 10) /* Drive Strength */ 84#define AT91_DDRSDRC_TIMEOUT (3 << 12) /* Time to define when Low Power Mode is enabled */ 85#define AT91_DDRSDRC_TIMEOUT_0_CLK_CYCLES (0 << 12) 86#define AT91_DDRSDRC_TIMEOUT_64_CLK_CYCLES (1 << 12) 87#define AT91_DDRSDRC_TIMEOUT_128_CLK_CYCLES (2 << 12) 88#define AT91_DDRSDRC_APDE (1 << 16) /* Active power down exit time */ 89#define AT91_DDRSDRC_UPD_MR (3 << 20) /* Update load mode register and extended mode register */ 90 91#define AT91_DDRSDRC_MDR 0x20 /* Memory Device Register */ 92#define AT91_DDRSDRC_MD (7 << 0) /* Memory Device Type */ 93#define AT91_DDRSDRC_MD_SDR 0 94#define AT91_DDRSDRC_MD_LOW_POWER_SDR 1 95#define AT91_DDRSDRC_MD_LOW_POWER_DDR 3 96#define AT91_DDRSDRC_MD_LPDDR3 5 97#define AT91_DDRSDRC_MD_DDR2 6 /* [SAM9 Only] */ 98#define AT91_DDRSDRC_MD_LPDDR2 7 99#define AT91_DDRSDRC_DBW (1 << 4) /* Data Bus Width */ 100#define AT91_DDRSDRC_DBW_32BITS (0 << 4) 101#define AT91_DDRSDRC_DBW_16BITS (1 << 4) 102 103#define AT91_DDRSDRC_DLL 0x24 /* DLL Information Register */ 104#define AT91_DDRSDRC_MDINC (1 << 0) /* Master Delay increment */ 105#define AT91_DDRSDRC_MDDEC (1 << 1) /* Master Delay decrement */ 106#define AT91_DDRSDRC_MDOVF (1 << 2) /* Master Delay Overflow */ 107#define AT91_DDRSDRC_MDVAL (0xff << 8) /* Master Delay value */ 108 109#define AT91_DDRSDRC_HS 0x2C /* High Speed Register [SAM9 Only] */ 110#define AT91_DDRSDRC_DIS_ATCP_RD (1 << 2) /* Anticip read access is disabled */ 111 112#define AT91_DDRSDRC_DELAY(n) (0x30 + (0x4 * (n))) /* Delay I/O Register n */ 113 114#define AT91_DDRSDRC_WPMR 0xE4 /* Write Protect Mode Register [SAM9 Only] */ 115#define AT91_DDRSDRC_WP (1 << 0) /* Write protect enable */ 116#define AT91_DDRSDRC_WPKEY (0xffffff << 8) /* Write protect key */ 117#define AT91_DDRSDRC_KEY (0x444452 << 8) /* Write protect key = "DDR" */ 118 119#define AT91_DDRSDRC_WPSR 0xE8 /* Write Protect Status Register [SAM9 Only] */ 120#define AT91_DDRSDRC_WPVS (1 << 0) /* Write protect violation status */ 121#define AT91_DDRSDRC_WPVSRC (0xffff << 8) /* Write protect violation source */ 122 123#endif 124