qemu/migration/postcopy-ram.h
<<
>>
Prefs
   1/*
   2 * Postcopy migration for RAM
   3 *
   4 * Copyright 2013 Red Hat, Inc. and/or its affiliates
   5 *
   6 * Authors:
   7 *  Dave Gilbert  <dgilbert@redhat.com>
   8 *
   9 * This work is licensed under the terms of the GNU GPL, version 2 or later.
  10 * See the COPYING file in the top-level directory.
  11 *
  12 */
  13#ifndef QEMU_POSTCOPY_RAM_H
  14#define QEMU_POSTCOPY_RAM_H
  15
  16#include "qapi/qapi-types-migration.h"
  17
  18/* Return true if the host supports everything we need to do postcopy-ram */
  19bool postcopy_ram_supported_by_host(MigrationIncomingState *mis,
  20                                    Error **errp);
  21
  22/*
  23 * Make all of RAM sensitive to accesses to areas that haven't yet been written
  24 * and wire up anything necessary to deal with it.
  25 */
  26int postcopy_ram_incoming_setup(MigrationIncomingState *mis);
  27
  28/*
  29 * Initialise postcopy-ram, setting the RAM to a state where we can go into
  30 * postcopy later; must be called prior to any precopy.
  31 * called from ram.c's similarly named ram_postcopy_incoming_init
  32 */
  33int postcopy_ram_incoming_init(MigrationIncomingState *mis);
  34
  35/*
  36 * At the end of a migration where postcopy_ram_incoming_init was called.
  37 */
  38int postcopy_ram_incoming_cleanup(MigrationIncomingState *mis);
  39
  40/*
  41 * Userfault requires us to mark RAM as NOHUGEPAGE prior to discard
  42 * however leaving it until after precopy means that most of the precopy
  43 * data is still THPd
  44 */
  45int postcopy_ram_prepare_discard(MigrationIncomingState *mis);
  46
  47/*
  48 * Called at the start of each RAMBlock by the bitmap code.
  49 */
  50void postcopy_discard_send_init(MigrationState *ms, const char *name);
  51
  52/*
  53 * Called by the bitmap code for each chunk to discard.
  54 * May send a discard message, may just leave it queued to
  55 * be sent later.
  56 * @start,@length: a range of pages in the migration bitmap in the
  57 *  RAM block passed to postcopy_discard_send_init() (length=1 is one page)
  58 */
  59void postcopy_discard_send_range(MigrationState *ms, unsigned long start,
  60                                 unsigned long length);
  61
  62/*
  63 * Called at the end of each RAMBlock by the bitmap code.
  64 * Sends any outstanding discard messages.
  65 */
  66void postcopy_discard_send_finish(MigrationState *ms);
  67
  68/*
  69 * Place a page (from) at (host) efficiently
  70 *    There are restrictions on how 'from' must be mapped, in general best
  71 *    to use other postcopy_ routines to allocate.
  72 * returns 0 on success
  73 */
  74int postcopy_place_page(MigrationIncomingState *mis, void *host, void *from,
  75                        RAMBlock *rb);
  76
  77/*
  78 * Place a zero page at (host) atomically
  79 * returns 0 on success
  80 */
  81int postcopy_place_page_zero(MigrationIncomingState *mis, void *host,
  82                             RAMBlock *rb);
  83
  84/* The current postcopy state is read/set by postcopy_state_get/set
  85 * which update it atomically.
  86 * The state is updated as postcopy messages are received, and
  87 * in general only one thread should be writing to the state at any one
  88 * time, initially the main thread and then the listen thread;
  89 * Corner cases are where either thread finishes early and/or errors.
  90 * The state is checked as messages are received to ensure that
  91 * the source is sending us messages in the correct order.
  92 * The state is also used by the RAM reception code to know if it
  93 * has to place pages atomically, and the cleanup code at the end of
  94 * the main thread to know if it has to delay cleanup until the end
  95 * of postcopy.
  96 */
  97typedef enum {
  98    POSTCOPY_INCOMING_NONE = 0,  /* Initial state - no postcopy */
  99    POSTCOPY_INCOMING_ADVISE,
 100    POSTCOPY_INCOMING_DISCARD,
 101    POSTCOPY_INCOMING_LISTENING,
 102    POSTCOPY_INCOMING_RUNNING,
 103    POSTCOPY_INCOMING_END
 104} PostcopyState;
 105
 106PostcopyState postcopy_state_get(void);
 107/* Set the state and return the old state */
 108PostcopyState postcopy_state_set(PostcopyState new_state);
 109
 110void postcopy_fault_thread_notify(MigrationIncomingState *mis);
 111
 112/*
 113 * To be called once at the start before any device initialisation
 114 */
 115void postcopy_infrastructure_init(void);
 116
 117/* Add a notifier to a list to be called when checking whether the devices
 118 * can support postcopy.
 119 * It's data is a *PostcopyNotifyData
 120 * It should return 0 if OK, or a negative value on failure.
 121 * On failure it must set the data->errp to an error.
 122 *
 123 */
 124enum PostcopyNotifyReason {
 125    POSTCOPY_NOTIFY_PROBE = 0,
 126    POSTCOPY_NOTIFY_INBOUND_ADVISE,
 127    POSTCOPY_NOTIFY_INBOUND_LISTEN,
 128    POSTCOPY_NOTIFY_INBOUND_END,
 129};
 130
 131struct PostcopyNotifyData {
 132    enum PostcopyNotifyReason reason;
 133};
 134
 135void postcopy_add_notifier(NotifierWithReturn *nn);
 136void postcopy_remove_notifier(NotifierWithReturn *n);
 137/* Call the notifier list set by postcopy_add_start_notifier */
 138int postcopy_notify(enum PostcopyNotifyReason reason, Error **errp);
 139
 140void postcopy_thread_create(MigrationIncomingState *mis,
 141                            QemuThread *thread, const char *name,
 142                            void *(*fn)(void *), int joinable);
 143
 144struct PostCopyFD;
 145
 146/* ufd is a pointer to the struct uffd_msg *TODO: more Portable! */
 147typedef int (*pcfdhandler)(struct PostCopyFD *pcfd, void *ufd);
 148/* Notification to wake, either on place or on reception of
 149 * a fault on something that's already arrived (race)
 150 */
 151typedef int (*pcfdwake)(struct PostCopyFD *pcfd, RAMBlock *rb, uint64_t offset);
 152
 153struct PostCopyFD {
 154    int fd;
 155    /* Data to pass to handler */
 156    void *data;
 157    /* Handler to be called whenever we get a poll event */
 158    pcfdhandler handler;
 159    /* Notification to wake shared client */
 160    pcfdwake waker;
 161    /* A string to use in error messages */
 162    const char *idstr;
 163};
 164
 165/* Register a userfaultfd owned by an external process for
 166 * shared memory.
 167 */
 168void postcopy_register_shared_ufd(struct PostCopyFD *pcfd);
 169void postcopy_unregister_shared_ufd(struct PostCopyFD *pcfd);
 170/* Call each of the shared 'waker's registered telling them of
 171 * availability of a block.
 172 */
 173int postcopy_notify_shared_wake(RAMBlock *rb, uint64_t offset);
 174/* postcopy_wake_shared: Notify a client ufd that a page is available
 175 *
 176 * Returns 0 on success
 177 *
 178 * @pcfd: Structure with fd, handler and name as above
 179 * @client_addr: Address in the client program, not QEMU
 180 * @rb: The RAMBlock the page is in
 181 */
 182int postcopy_wake_shared(struct PostCopyFD *pcfd, uint64_t client_addr,
 183                         RAMBlock *rb);
 184/* Callback from shared fault handlers to ask for a page */
 185int postcopy_request_shared_page(struct PostCopyFD *pcfd, RAMBlock *rb,
 186                                 uint64_t client_addr, uint64_t offset);
 187
 188/* Hard-code channels for now for postcopy preemption */
 189enum PostcopyChannels {
 190    RAM_CHANNEL_PRECOPY = 0,
 191    RAM_CHANNEL_POSTCOPY = 1,
 192    RAM_CHANNEL_MAX,
 193};
 194
 195void postcopy_preempt_new_channel(MigrationIncomingState *mis, QEMUFile *file);
 196void postcopy_preempt_setup(MigrationState *s);
 197int postcopy_preempt_establish_channel(MigrationState *s);
 198bool postcopy_is_paused(MigrationStatus status);
 199void mark_postcopy_blocktime_begin(uintptr_t addr, uint32_t ptid,
 200                                   RAMBlock *rb);
 201
 202#endif
 203