1/* 2 * Copyright 2008 Freescale Semiconductor, Inc. 3 * 4 * SPDX-License-Identifier: GPL-2.0 5 */ 6 7#include <common.h> 8#include <i2c.h> 9 10#include <fsl_ddr_sdram.h> 11#include <fsl_ddr_dimm_params.h> 12 13void get_spd(ddr2_spd_eeprom_t *spd, unsigned char i2c_address) 14{ 15 i2c_read(i2c_address, 0, 1, (uchar *)spd, sizeof(ddr2_spd_eeprom_t)); 16 17 /* We use soldered memory, but use an SPD EEPROM to describe it. 18 * The SPD has an unspecified dimm type, but the DDR2 initialization 19 * code requires a specific type to be specified. This sets the type 20 * as a standard unregistered SO-DIMM. */ 21 if (spd->dimm_type == 0) { 22 spd->dimm_type = 0x4; 23 ((uchar *)spd)[63] += 0x4; 24 } 25} 26 27void fsl_ddr_board_options(memctl_options_t *popts, 28 dimm_params_t *pdimm, 29 unsigned int ctrl_num) 30{ 31 /* 32 * Factors to consider for clock adjust: 33 * - number of chips on bus 34 * - position of slot 35 * - DDR1 vs. DDR2? 36 * - ??? 37 * 38 * This needs to be determined on a board-by-board basis. 39 * 0110 3/4 cycle late 40 * 0111 7/8 cycle late 41 */ 42 popts->clk_adjust = 7; 43 44 /* 45 * Factors to consider for CPO: 46 * - frequency 47 * - ddr1 vs. ddr2 48 */ 49 popts->cpo_override = 9; 50 51 /* 52 * Factors to consider for write data delay: 53 * - number of DIMMs 54 * 55 * 1 = 1/4 clock delay 56 * 2 = 1/2 clock delay 57 * 3 = 3/4 clock delay 58 * 4 = 1 clock delay 59 * 5 = 5/4 clock delay 60 * 6 = 3/2 clock delay 61 */ 62 popts->write_data_delay = 3; 63 64 /* 65 * Factors to consider for half-strength driver enable: 66 * - number of DIMMs installed 67 */ 68 popts->half_strength_driver_enable = 0; 69} 70