1/* 2 * include/configs/salvator-x.h 3 * This file is Salvator-X board configuration. 4 * 5 * Copyright (C) 2015 Renesas Electronics Corporation 6 * 7 * SPDX-License-Identifier: GPL-2.0+ 8 */ 9 10#ifndef __SALVATOR_X_H 11#define __SALVATOR_X_H 12 13#undef DEBUG 14 15#define CONFIG_RCAR_BOARD_STRING "Salvator-X" 16 17#include "rcar-gen3-common.h" 18 19/* SCIF */ 20#define CONFIG_SCIF_CONSOLE 21#define CONFIG_CONS_SCIF2 22#define CONFIG_CONS_INDEX 2 23#define CONFIG_SH_SCIF_CLK_FREQ CONFIG_SYS_CLK_FREQ 24 25/* [A] Hyper Flash */ 26/* use to RPC(SPI Multi I/O Bus Controller) */ 27#define CONFIG_SYS_NO_FLASH 28#define CONFIG_ENV_IS_NOWHERE 29 30/* Board Clock */ 31/* XTAL_CLK : 33.33MHz */ 32#define RCAR_XTAL_CLK 33333333u 33#define CONFIG_SYS_CLK_FREQ RCAR_XTAL_CLK 34/* ch0to2 CPclk, ch3to11 S3D2_PEREclk, ch12to14 S3D2_RTclk */ 35/* CPclk 16.66MHz, S3D2 133.33MHz */ 36#define CONFIG_CP_CLK_FREQ (CONFIG_SYS_CLK_FREQ / 2) 37#define CONFIG_PLL1_CLK_FREQ (CONFIG_SYS_CLK_FREQ * 192 / 2) 38#define CONFIG_S3D2_CLK_FREQ (266666666u/2) 39 40/* Generic Timer Definitions (use in assembler source) */ 41#define COUNTER_FREQUENCY 0xFE502A /* 16.66MHz from CPclk */ 42 43/* Generic Interrupt Controller Definitions */ 44#define CONFIG_GICV2 45#define GICD_BASE 0xF1010000 46#define GICC_BASE 0xF1020000 47 48/* Module stop status bits */ 49/* MFIS, SCIF1 */ 50#define CONFIG_SMSTP2_ENA 0x00002040 51/* INTC-AP, IRQC */ 52#define CONFIG_SMSTP4_ENA 0x00000180 53 54#endif /* __SALVATOR_X_H */ 55