1/* 2 * Copyright 2016 Freescale Semiconductor 3 * 4 * SPDX-License-Identifier: GPL-2.0+ 5 */ 6 7#ifndef __LS1046ARDB_H__ 8#define __LS1046ARDB_H__ 9 10#include "ls1046a_common.h" 11 12#ifdef CONFIG_SD_BOOT 13#define CONFIG_SYS_TEXT_BASE 0x82000000 14#else 15#define CONFIG_SYS_TEXT_BASE 0x40100000 16#endif 17 18#define CONFIG_SYS_CLK_FREQ 100000000 19#define CONFIG_DDR_CLK_FREQ 100000000 20 21#define CONFIG_LAYERSCAPE_NS_ACCESS 22#define CONFIG_MISC_INIT_R 23 24#define CONFIG_DIMM_SLOTS_PER_CTLR 1 25/* Physical Memory Map */ 26#define CONFIG_CHIP_SELECTS_PER_CTRL 4 27#define CONFIG_NR_DRAM_BANKS 2 28 29#define CONFIG_DDR_SPD 30#define SPD_EEPROM_ADDRESS 0x51 31#define CONFIG_SYS_SPD_BUS_NUM 0 32 33#define CONFIG_DDR_ECC 34#define CONFIG_ECC_INIT_VIA_DDRCONTROLLER 35#define CONFIG_MEM_INIT_VALUE 0xdeadbeef 36#define CONFIG_FSL_DDR_BIST /* enable built-in memory test */ 37#define CONFIG_FSL_DDR_INTERACTIVE /* Interactive debugging */ 38 39#ifdef CONFIG_RAMBOOT_PBL 40#define CONFIG_SYS_FSL_PBL_PBI board/freescale/ls1046ardb/ls1046ardb_pbi.cfg 41#endif 42 43#ifdef CONFIG_SD_BOOT 44#ifdef CONFIG_EMMC_BOOT 45#define CONFIG_SYS_FSL_PBL_RCW \ 46 board/freescale/ls1046ardb/ls1046ardb_rcw_emmc.cfg 47#else 48#define CONFIG_SYS_FSL_PBL_RCW board/freescale/ls1046ardb/ls1046ardb_rcw_sd.cfg 49#endif 50#endif 51 52/* IFC */ 53#define CONFIG_FSL_IFC 54 55/* 56 * NAND Flash Definitions 57 */ 58#define CONFIG_NAND_FSL_IFC 59 60#define CONFIG_SYS_NAND_BASE 0x7e800000 61#define CONFIG_SYS_NAND_BASE_PHYS CONFIG_SYS_NAND_BASE 62 63#define CONFIG_SYS_NAND_CSPR_EXT (0x0) 64#define CONFIG_SYS_NAND_CSPR (CSPR_PHYS_ADDR(CONFIG_SYS_NAND_BASE_PHYS) \ 65 | CSPR_PORT_SIZE_8 \ 66 | CSPR_MSEL_NAND \ 67 | CSPR_V) 68#define CONFIG_SYS_NAND_AMASK IFC_AMASK(64 * 1024) 69#define CONFIG_SYS_NAND_CSOR (CSOR_NAND_ECC_ENC_EN /* ECC on encode */ \ 70 | CSOR_NAND_ECC_DEC_EN /* ECC on decode */ \ 71 | CSOR_NAND_ECC_MODE_8 /* 8-bit ECC */ \ 72 | CSOR_NAND_RAL_3 /* RAL = 3 Bytes */ \ 73 | CSOR_NAND_PGS_4K /* Page Size = 4K */ \ 74 | CSOR_NAND_SPRZ_224 /* Spare size = 224 */ \ 75 | CSOR_NAND_PB(64)) /* 64 Pages Per Block */ 76 77#define CONFIG_SYS_NAND_ONFI_DETECTION 78 79#define CONFIG_SYS_NAND_FTIM0 (FTIM0_NAND_TCCST(0x7) | \ 80 FTIM0_NAND_TWP(0x18) | \ 81 FTIM0_NAND_TWCHT(0x7) | \ 82 FTIM0_NAND_TWH(0xa)) 83#define CONFIG_SYS_NAND_FTIM1 (FTIM1_NAND_TADLE(0x32) | \ 84 FTIM1_NAND_TWBE(0x39) | \ 85 FTIM1_NAND_TRR(0xe) | \ 86 FTIM1_NAND_TRP(0x18)) 87#define CONFIG_SYS_NAND_FTIM2 (FTIM2_NAND_TRAD(0xf) | \ 88 FTIM2_NAND_TREH(0xa) | \ 89 FTIM2_NAND_TWHRE(0x1e)) 90#define CONFIG_SYS_NAND_FTIM3 0x0 91 92#define CONFIG_SYS_NAND_BASE_LIST { CONFIG_SYS_NAND_BASE } 93#define CONFIG_SYS_MAX_NAND_DEVICE 1 94#define CONFIG_MTD_NAND_VERIFY_WRITE 95#define CONFIG_CMD_NAND 96 97#define CONFIG_SYS_NAND_BLOCK_SIZE (128 * 1024) 98 99/* 100 * CPLD 101 */ 102#define CONFIG_SYS_CPLD_BASE 0x7fb00000 103#define CPLD_BASE_PHYS CONFIG_SYS_CPLD_BASE 104 105#define CONFIG_SYS_CPLD_CSPR_EXT (0x0) 106#define CONFIG_SYS_CPLD_CSPR (CSPR_PHYS_ADDR(CPLD_BASE_PHYS) | \ 107 CSPR_PORT_SIZE_8 | \ 108 CSPR_MSEL_GPCM | \ 109 CSPR_V) 110#define CONFIG_SYS_CPLD_AMASK IFC_AMASK(64 * 1024) 111#define CONFIG_SYS_CPLD_CSOR CSOR_NOR_ADM_SHIFT(16) 112 113/* CPLD Timing parameters for IFC GPCM */ 114#define CONFIG_SYS_CPLD_FTIM0 (FTIM0_GPCM_TACSE(0x0e) | \ 115 FTIM0_GPCM_TEADC(0x0e) | \ 116 FTIM0_GPCM_TEAHC(0x0e)) 117#define CONFIG_SYS_CPLD_FTIM1 (FTIM1_GPCM_TACO(0xff) | \ 118 FTIM1_GPCM_TRAD(0x3f)) 119#define CONFIG_SYS_CPLD_FTIM2 (FTIM2_GPCM_TCS(0xf) | \ 120 FTIM2_GPCM_TCH(0xf) | \ 121 FTIM2_GPCM_TWP(0x3E)) 122#define CONFIG_SYS_CPLD_FTIM3 0x0 123 124/* IFC Timing Params */ 125#define CONFIG_SYS_CSPR0_EXT CONFIG_SYS_NAND_CSPR_EXT 126#define CONFIG_SYS_CSPR0 CONFIG_SYS_NAND_CSPR 127#define CONFIG_SYS_AMASK0 CONFIG_SYS_NAND_AMASK 128#define CONFIG_SYS_CSOR0 CONFIG_SYS_NAND_CSOR 129#define CONFIG_SYS_CS0_FTIM0 CONFIG_SYS_NAND_FTIM0 130#define CONFIG_SYS_CS0_FTIM1 CONFIG_SYS_NAND_FTIM1 131#define CONFIG_SYS_CS0_FTIM2 CONFIG_SYS_NAND_FTIM2 132#define CONFIG_SYS_CS0_FTIM3 CONFIG_SYS_NAND_FTIM3 133 134#define CONFIG_SYS_CSPR2_EXT CONFIG_SYS_CPLD_CSPR_EXT 135#define CONFIG_SYS_CSPR2 CONFIG_SYS_CPLD_CSPR 136#define CONFIG_SYS_AMASK2 CONFIG_SYS_CPLD_AMASK 137#define CONFIG_SYS_CSOR2 CONFIG_SYS_CPLD_CSOR 138#define CONFIG_SYS_CS2_FTIM0 CONFIG_SYS_CPLD_FTIM0 139#define CONFIG_SYS_CS2_FTIM1 CONFIG_SYS_CPLD_FTIM1 140#define CONFIG_SYS_CS2_FTIM2 CONFIG_SYS_CPLD_FTIM2 141#define CONFIG_SYS_CS2_FTIM3 CONFIG_SYS_CPLD_FTIM3 142 143/* EEPROM */ 144#define CONFIG_ID_EEPROM 145#define CONFIG_SYS_I2C_EEPROM_NXID 146#define CONFIG_SYS_EEPROM_BUS_NUM 0 147#define CONFIG_SYS_I2C_EEPROM_ADDR 0x53 148#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1 149#define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3 150#define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5 151#define I2C_RETIMER_ADDR 0x18 152 153/* PMIC */ 154#define CONFIG_POWER 155#ifdef CONFIG_POWER 156#define CONFIG_POWER_I2C 157#endif 158 159/* 160 * Environment 161 */ 162#define CONFIG_ENV_OVERWRITE 163 164#if defined(CONFIG_SD_BOOT) 165#define CONFIG_ENV_IS_IN_MMC 166#define CONFIG_SYS_MMC_ENV_DEV 0 167#define CONFIG_ENV_OFFSET (1024 * 1024) 168#define CONFIG_ENV_SIZE 0x2000 169#else 170#define CONFIG_ENV_IS_IN_SPI_FLASH 171#define CONFIG_ENV_SIZE 0x2000 /* 8KB */ 172#define CONFIG_ENV_OFFSET 0x200000 /* 2MB */ 173#define CONFIG_ENV_SECT_SIZE 0x40000 /* 256KB */ 174#endif 175 176/* FMan */ 177#ifdef CONFIG_SYS_DPAA_FMAN 178#define CONFIG_FMAN_ENET 179#define CONFIG_PHYLIB 180#define CONFIG_PHYLIB_10G 181#define CONFIG_PHY_GIGE /* Include GbE speed/duplex detection */ 182 183#define CONFIG_PHY_REALTEK 184#define CONFIG_PHY_AQUANTIA 185#define AQR105_IRQ_MASK 0x80000000 186 187#define RGMII_PHY1_ADDR 0x1 188#define RGMII_PHY2_ADDR 0x2 189 190#define SGMII_PHY1_ADDR 0x3 191#define SGMII_PHY2_ADDR 0x4 192 193#define FM1_10GEC1_PHY_ADDR 0x0 194 195#define CONFIG_ETHPRIME "FM1@DTSEC3" 196#endif 197 198/* QSPI device */ 199#ifdef CONFIG_FSL_QSPI 200#define CONFIG_SPI_FLASH_SPANSION 201#define FSL_QSPI_FLASH_SIZE (1 << 26) 202#define FSL_QSPI_FLASH_NUM 2 203#define CONFIG_SPI_FLASH_BAR 204#endif 205 206/* USB */ 207#define CONFIG_HAS_FSL_XHCI_USB 208#ifdef CONFIG_HAS_FSL_XHCI_USB 209#define CONFIG_USB_XHCI_HCD 210#define CONFIG_USB_XHCI_FSL 211#define CONFIG_USB_XHCI_DWC3 212#define CONFIG_USB_MAX_CONTROLLER_COUNT 3 213#define CONFIG_SYS_USB_XHCI_MAX_ROOT_PORTS 2 214#define CONFIG_CMD_USB 215#define CONFIG_USB_STORAGE 216#endif 217 218/* SATA */ 219#define CONFIG_LIBATA 220#define CONFIG_SCSI_AHCI 221#define CONFIG_SCSI_AHCI_PLAT 222#define CONFIG_SCSI 223 224#define CONFIG_SYS_SATA AHCI_BASE_ADDR 225 226#define CONFIG_SYS_SCSI_MAX_SCSI_ID 1 227#define CONFIG_SYS_SCSI_MAX_LUN 1 228#define CONFIG_SYS_SCSI_MAX_DEVICE (CONFIG_SYS_SCSI_MAX_SCSI_ID * \ 229 CONFIG_SYS_SCSI_MAX_LUN) 230 231#define CONFIG_BOOTCOMMAND "sf probe 0:0;sf read $kernel_load" \ 232 "$kernel_start $kernel_size;" \ 233 "bootm $kernel_load" 234 235#define MTDPARTS_DEFAULT "mtdparts=1550000.quadspi:1m(rcw)," \ 236 "15m(u-boot),48m(kernel.itb);" \ 237 "7e800000.flash:16m(nand_uboot)," \ 238 "48m(nand_kernel),448m(nand_free)" 239 240#endif /* __LS1046ARDB_H__ */ 241