LXR uboot/board/renesas/silk/silk.c

   1// SPDX-License-Identifier: GPL-2.0
   2/*
   3 * board/renesas/silk/silk.c
   4 *
   5 * Copyright (C) 2015 Renesas Electronics Corporation
   6 * Copyright (C) 2015 Cogent Embedded, Inc.
   7 */
   8
   9#include <common.h>
  10#include <malloc.h>
  11#include <dm.h>
  12#include <dm/platform_data/serial_sh.h>
  13#include <environment.h>
  14#include <asm/processor.h>
  15#include <asm/mach-types.h>
  16#include <asm/io.h>
  17#include <linux/errno.h>
  18#include <asm/arch/sys_proto.h>
  19#include <asm/gpio.h>
  20#include <asm/arch/rmobile.h>
  21#include <asm/arch/rcar-mstp.h>
  22#include <asm/arch/mmc.h>
  23#include <asm/arch/sh_sdhi.h>
  24#include <netdev.h>
  25#include <miiphy.h>
  26#include <i2c.h>
  27#include <div64.h>
  28#include "qos.h"
  29
  30DECLARE_GLOBAL_DATA_PTR;
  31
  32void s_init(void)
  33{
  34        struct rcar_rwdt *rwdt = (struct rcar_rwdt *)RWDT_BASE;
  35        struct rcar_swdt *swdt = (struct rcar_swdt *)SWDT_BASE;
  36
  37        /* Watchdog init */
  38        writel(0xA5A5A500, &rwdt->rwtcsra);
  39        writel(0xA5A5A500, &swdt->swtcsra);
  40
  41        /* QoS */
  42        qos_init();
  43}
  44
  45#define TMU0_MSTP125    BIT(25)
  46#define MMC0_MSTP315    BIT(15)
  47
  48#define SD1CKCR         0xE6150078
  49#define SD_97500KHZ     0x7
  50
  51int board_early_init_f(void)
  52{
  53        /* TMU */
  54        mstp_clrbits_le32(MSTPSR1, SMSTPCR1, TMU0_MSTP125);
  55
  56        /* Set SD1 to the 97.5MHz */
  57        writel(SD_97500KHZ, SD1CKCR);
  58
  59        return 0;
  60}
  61
  62#define ETHERNET_PHY_RESET      56      /* GPIO 1 24 */
  63
  64int board_init(void)
  65{
  66        /* adress of boot parameters */
  67        gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100;
  68
  69        /* Force ethernet PHY out of reset */
  70        gpio_request(ETHERNET_PHY_RESET, "phy_reset");
  71        gpio_direction_output(ETHERNET_PHY_RESET, 0);
  72        mdelay(20);
  73        gpio_direction_output(ETHERNET_PHY_RESET, 1);
  74        udelay(1);
  75
  76        return 0;
  77}
  78
  79int dram_init(void)
  80{
  81        if (fdtdec_setup_mem_size_base() != 0)
  82                return -EINVAL;
  83
  84        return 0;
  85}
  86
  87int dram_init_banksize(void)
  88{
  89        fdtdec_setup_memory_banksize();
  90
  91        return 0;
  92}
  93
  94/* porter has KSZ8041RNLI */
  95#define PHY_CONTROL1            0x1E
  96#define PHY_LED_MODE            0xC0000
  97#define PHY_LED_MODE_ACK        0x4000
  98int board_phy_config(struct phy_device *phydev)
  99{
 100        int ret = phy_read(phydev, MDIO_DEVAD_NONE, PHY_CONTROL1);
 101        ret &= ~PHY_LED_MODE;
 102        ret |= PHY_LED_MODE_ACK;
 103        ret = phy_write(phydev, MDIO_DEVAD_NONE, PHY_CONTROL1, (u16)ret);
 104
 105        return 0;
 106}
 107
 108void reset_cpu(ulong addr)
 109{
 110        struct udevice *dev;
 111        const u8 pmic_bus = 1;
 112        const u8 pmic_addr = 0x5a;
 113        u8 data;
 114        int ret;
 115
 116        ret = i2c_get_chip_for_busnum(pmic_bus, pmic_addr, 1, &dev);
 117        if (ret)
 118                hang();
 119
 120        ret = dm_i2c_read(dev, 0x13, &data, 1);
 121        if (ret)
 122                hang();
 123
 124        data |= BIT(1);
 125
 126        ret = dm_i2c_write(dev, 0x13, &data, 1);
 127        if (ret)
 128                hang();
 129}
 130
 131enum env_location env_get_location(enum env_operation op, int prio)
 132{
 133        const u32 load_magic = 0xb33fc0de;
 134
 135        /* Block environment access if loaded using JTAG */
 136        if ((readl(CONFIG_SPL_TEXT_BASE + 0x24) == load_magic) &&
 137            (op != ENVOP_INIT))
 138                return ENVL_UNKNOWN;
 139
 140        if (prio)
 141                return ENVL_UNKNOWN;
 142
 143        return ENVL_SPI_FLASH;
 144}
 145