1/* SPDX-License-Identifier: GPL-2.0+ */ 2/* 3 * board.h 4 * 5 * EETS GmbH PDU001 board information header 6 * 7 * Copyright (C) 2018 EETS GmbH - http://www.eets.ch/ 8 * 9 * Copyright (C) 2011, Texas Instruments, Incorporated - http://www.ti.com/ 10 */ 11 12#ifndef _BOARD_H_ 13#define _BOARD_H_ 14 15/* 16 * We have two pin mux functions that must exist. First we need I2C0 to 17 * access the TPS65910 PMIC located on the M2 computing module. 18 * Second, if we want low-level debugging or a early UART (ie. before the 19 * pin controller driver is running), we need one of the UART ports UART0 to 20 * UART5 (usually UART3 since it is wired to K2). 21 * In case of I2C0 access we explicitly don't rely on the the ROM but we could 22 * do so as we use the primary mode (mode 0) for I2C0. 23 * All other multiplexing and pin configuration is done by the DT once it 24 * gets parsed by the pin controller driver. 25 * However we relay on the ROM to configure the pins of MMC0 (eMMC) as well 26 * as MMC1 (microSD card-cage) since these are our boot devices. 27 */ 28void enable_uart0_pin_mux(void); 29void enable_uart1_pin_mux(void); 30void enable_uart2_pin_mux(void); 31void enable_uart3_pin_mux(void); 32void enable_uart4_pin_mux(void); 33void enable_uart5_pin_mux(void); 34void enable_uart_pin_mux(u32 addr); 35void enable_i2c0_pin_mux(void); 36 37#endif 38