LXR uboot/include/configs/imx8mq

   1/* SPDX-License-Identifier: GPL-2.0+ */
   2/*
   3 * Copyright 2018 NXP
   4 */
   5
   6#ifndef __IMX8M_EVK_H
   7#define __IMX8M_EVK_H
   8
   9#include <linux/sizes.h>
  10#include <asm/arch/imx-regs.h>
  11
  12#ifdef CONFIG_SECURE_BOOT
  13#define CONFIG_CSF_SIZE                 0x2000 /* 8K region */
  14#endif
  15
  16#define CONFIG_SPL_MAX_SIZE             (124 * 1024)
  17#define CONFIG_SYS_MONITOR_LEN          (512 * 1024)
  18#define CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR
  19#define CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR 0x300
  20#define CONFIG_SYS_MMCSD_FS_BOOT_PARTITION      1
  21
  22#ifdef CONFIG_SPL_BUILD
  23/*#define CONFIG_ENABLE_DDR_TRAINING_DEBUG*/
  24#define CONFIG_SPL_WATCHDOG_SUPPORT
  25#define CONFIG_SPL_DRIVERS_MISC_SUPPORT
  26#define CONFIG_SPL_POWER_SUPPORT
  27#define CONFIG_SPL_I2C_SUPPORT
  28#define CONFIG_SPL_LDSCRIPT             "arch/arm/cpu/armv8/u-boot-spl.lds"
  29#define CONFIG_SPL_STACK                0x187FF0
  30#define CONFIG_SPL_LIBCOMMON_SUPPORT
  31#define CONFIG_SPL_LIBGENERIC_SUPPORT
  32#define CONFIG_SPL_GPIO_SUPPORT
  33#define CONFIG_SPL_MMC_SUPPORT
  34#define CONFIG_SPL_BSS_START_ADDR      0x00180000
  35#define CONFIG_SPL_BSS_MAX_SIZE        0x2000   /* 8 KB */
  36#define CONFIG_SYS_SPL_MALLOC_START    0x42200000
  37#define CONFIG_SYS_SPL_MALLOC_SIZE    0x80000   /* 512 KB */
  38#define CONFIG_SYS_SPL_PTE_RAM_BASE    0x41580000
  39
  40/* malloc f used before GD_FLG_FULL_MALLOC_INIT set */
  41#define CONFIG_MALLOC_F_ADDR            0x182000
  42/* For RAW image gives a error info not panic */
  43#define CONFIG_SPL_ABORT_ON_RAW_IMAGE
  44
  45#undef CONFIG_DM_MMC
  46#undef CONFIG_DM_PMIC
  47#undef CONFIG_DM_PMIC_PFUZE100
  48
  49#define CONFIG_SYS_I2C
  50#define CONFIG_SYS_I2C_MXC_I2C1         /* enable I2C bus 1 */
  51#define CONFIG_SYS_I2C_MXC_I2C2         /* enable I2C bus 2 */
  52#define CONFIG_SYS_I2C_MXC_I2C3         /* enable I2C bus 3 */
  53
  54#define CONFIG_ENV_VARS_UBOOT_RUNTIME_CONFIG
  55
  56#define CONFIG_POWER
  57#define CONFIG_POWER_I2C
  58#define CONFIG_POWER_PFUZE100
  59#define CONFIG_POWER_PFUZE100_I2C_ADDR 0x08
  60#endif
  61
  62#define CONFIG_REMAKE_ELF
  63
  64#define CONFIG_BOARD_EARLY_INIT_F
  65#define CONFIG_BOARD_LATE_INIT
  66
  67#undef CONFIG_CMD_EXPORTENV
  68#undef CONFIG_CMD_IMPORTENV
  69#undef CONFIG_CMD_IMLS
  70
  71#undef CONFIG_CMD_CRC32
  72
  73/* ENET Config */
  74/* ENET1 */
  75#if defined(CONFIG_CMD_NET)
  76#define CONFIG_CMD_PING
  77#define CONFIG_CMD_DHCP
  78#define CONFIG_CMD_MII
  79#define CONFIG_MII
  80#define CONFIG_ETHPRIME                 "FEC"
  81
  82#define CONFIG_FEC_MXC
  83#define CONFIG_FEC_XCV_TYPE             RGMII
  84#define CONFIG_FEC_MXC_PHYADDR          0
  85#define FEC_QUIRK_ENET_MAC
  86
  87#define CONFIG_PHY_GIGE
  88#define IMX_FEC_BASE                    0x30BE0000
  89
  90#define CONFIG_PHYLIB
  91#define CONFIG_PHY_ATHEROS
  92#endif
  93
  94#define CONFIG_MFG_ENV_SETTINGS \
  95        "mfgtool_args=setenv bootargs console=${console},${baudrate} " \
  96                "rdinit=/linuxrc " \
  97                "g_mass_storage.stall=0 g_mass_storage.removable=1 " \
  98                "g_mass_storage.idVendor=0x066F g_mass_storage.idProduct=0x37FF "\
  99                "g_mass_storage.iSerialNumber=\"\" "\
 100                "clk_ignore_unused "\
 101                "\0" \
 102        "initrd_addr=0x43800000\0" \
 103        "initrd_high=0xffffffff\0" \
 104        "bootcmd_mfg=run mfgtool_args;booti ${loadaddr} ${initrd_addr} ${fdt_addr};\0" \
 105/* Initial environment variables */
 106#define CONFIG_EXTRA_ENV_SETTINGS               \
 107        CONFIG_MFG_ENV_SETTINGS \
 108        "script=boot.scr\0" \
 109        "image=Image\0" \
 110        "console=ttymxc0,115200 earlycon=ec_imx6q,0x30860000,115200\0" \
 111        "fdt_addr=0x43000000\0"                 \
 112        "fdt_high=0xffffffffffffffff\0"         \
 113        "boot_fdt=try\0" \
 114        "fdt_file=fsl-imx8mq-evk.dtb\0" \
 115        "initrd_addr=0x43800000\0"              \
 116        "initrd_high=0xffffffffffffffff\0" \
 117        "mmcdev="__stringify(CONFIG_SYS_MMC_ENV_DEV)"\0" \
 118        "mmcpart=" __stringify(CONFIG_SYS_MMC_IMG_LOAD_PART) "\0" \
 119        "mmcroot=" CONFIG_MMCROOT " rootwait rw\0" \
 120        "mmcautodetect=yes\0" \
 121        "mmcargs=setenv bootargs console=${console} root=${mmcroot}\0 " \
 122        "loadbootscript=fatload mmc ${mmcdev}:${mmcpart} ${loadaddr} ${script};\0" \
 123        "bootscript=echo Running bootscript from mmc ...; " \
 124                "source\0" \
 125        "loadimage=fatload mmc ${mmcdev}:${mmcpart} ${loadaddr} ${image}\0" \
 126        "loadfdt=fatload mmc ${mmcdev}:${mmcpart} ${fdt_addr} ${fdt_file}\0" \
 127        "mmcboot=echo Booting from mmc ...; " \
 128                "run mmcargs; " \
 129                "if test ${boot_fdt} = yes || test ${boot_fdt} = try; then " \
 130                        "if run loadfdt; then " \
 131                                "booti ${loadaddr} - ${fdt_addr}; " \
 132                        "else " \
 133                                "echo WARN: Cannot load the DT; " \
 134                        "fi; " \
 135                "else " \
 136                        "echo wait for boot; " \
 137                "fi;\0" \
 138        "netargs=setenv bootargs console=${console} " \
 139                "root=/dev/nfs " \
 140                "ip=dhcp nfsroot=${serverip}:${nfsroot},v3,tcp\0" \
 141        "netboot=echo Booting from net ...; " \
 142                "run netargs;  " \
 143                "if test ${ip_dyn} = yes; then " \
 144                        "setenv get_cmd dhcp; " \
 145                "else " \
 146                        "setenv get_cmd tftp; " \
 147                "fi; " \
 148                "${get_cmd} ${loadaddr} ${image}; " \
 149                "if test ${boot_fdt} = yes || test ${boot_fdt} = try; then " \
 150                        "if ${get_cmd} ${fdt_addr} ${fdt_file}; then " \
 151                                "booti ${loadaddr} - ${fdt_addr}; " \
 152                        "else " \
 153                                "echo WARN: Cannot load the DT; " \
 154                        "fi; " \
 155                "else " \
 156                        "booti; " \
 157                "fi;\0"
 158
 159#define CONFIG_BOOTCOMMAND \
 160           "mmc dev ${mmcdev}; if mmc rescan; then " \
 161                   "if run loadbootscript; then " \
 162                           "run bootscript; " \
 163                   "else " \
 164                           "if run loadimage; then " \
 165                                   "run mmcboot; " \
 166                           "else run netboot; " \
 167                           "fi; " \
 168                   "fi; " \
 169           "else booti ${loadaddr} - ${fdt_addr}; fi"
 170
 171/* Link Definitions */
 172#define CONFIG_LOADADDR                 0x40480000
 173
 174#define CONFIG_SYS_LOAD_ADDR           CONFIG_LOADADDR
 175
 176#define CONFIG_SYS_INIT_RAM_ADDR        0x40000000
 177#define CONFIG_SYS_INIT_RAM_SIZE        0x80000
 178#define CONFIG_SYS_INIT_SP_OFFSET \
 179        (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 180#define CONFIG_SYS_INIT_SP_ADDR \
 181        (CONFIG_SYS_INIT_RAM_ADDR + CONFIG_SYS_INIT_SP_OFFSET)
 182
 183#define CONFIG_ENV_OVERWRITE
 184#define CONFIG_ENV_OFFSET               (64 * SZ_64K)
 185#define CONFIG_ENV_SIZE                 0x1000
 186#define CONFIG_SYS_MMC_ENV_DEV          1   /* USDHC2 */
 187#define CONFIG_MMCROOT                  "/dev/mmcblk1p2"  /* USDHC2 */
 188
 189/* Size of malloc() pool */
 190#define CONFIG_SYS_MALLOC_LEN           ((CONFIG_ENV_SIZE + (2 * 1024)) * 1024)
 191
 192#define CONFIG_SYS_SDRAM_BASE           0x40000000
 193#define PHYS_SDRAM                      0x40000000
 194#define PHYS_SDRAM_SIZE                 0xC0000000 /* 3GB DDR */
 195
 196#define CONFIG_SYS_MEMTEST_START        PHYS_SDRAM
 197#define CONFIG_SYS_MEMTEST_END          (CONFIG_SYS_MEMTEST_START + \
 198                                        (PHYS_SDRAM_SIZE >> 1))
 199
 200#define CONFIG_BAUDRATE                 115200
 201
 202#define CONFIG_MXC_UART
 203#define CONFIG_MXC_UART_BASE            UART1_BASE_ADDR
 204
 205/* Monitor Command Prompt */
 206#undef CONFIG_SYS_PROMPT
 207#define CONFIG_SYS_PROMPT               "u-boot=> "
 208#define CONFIG_SYS_PROMPT_HUSH_PS2      "> "
 209#define CONFIG_SYS_CBSIZE               1024
 210#define CONFIG_SYS_MAXARGS              64
 211#define CONFIG_SYS_BARGSIZE             CONFIG_SYS_CBSIZE
 212#define CONFIG_SYS_PBSIZE               (CONFIG_SYS_CBSIZE + \
 213                                        sizeof(CONFIG_SYS_PROMPT) + 16)
 214
 215#define CONFIG_IMX_BOOTAUX
 216
 217#define CONFIG_CMD_MMC
 218
 219#define CONFIG_SYS_FSL_USDHC_NUM        2
 220#define CONFIG_SYS_FSL_ESDHC_ADDR       0
 221
 222#define CONFIG_SYS_MMC_IMG_LOAD_PART    1
 223
 224#define CONFIG_MXC_GPIO
 225
 226#define CONFIG_CMD_FUSE
 227
 228/* I2C Configs */
 229#define CONFIG_SYS_I2C_SPEED              100000
 230
 231#define CONFIG_OF_SYSTEM_SETUP
 232
 233#ifndef CONFIG_SPL_BUILD
 234#define CONFIG_DM_PMIC
 235#endif
 236
 237#endif
 238