1/* 2 * Copyright (C) 2015, Bin Meng <bmeng.cn@gmail.com> 3 * 4 * SPDX-License-Identifier: GPL-2.0+ 5 */ 6 7#ifndef _ARCH_IRQ_H_ 8#define _ARCH_IRQ_H_ 9 10#include <dt-bindings/interrupt-router/intel-irq.h> 11 12/** 13 * Intel interrupt router configuration mechanism 14 * 15 * There are two known ways of Intel interrupt router configuration mechanism 16 * so far. On most cases, the IRQ routing configuraiton is controlled by PCI 17 * configuraiton registers on the legacy bridge, normally PCI BDF(0, 31, 0). 18 * On some newer platforms like BayTrail and Braswell, the IRQ routing is now 19 * in the IBASE register block where IBASE is memory-mapped. 20 */ 21enum pirq_config { 22 PIRQ_VIA_PCI, 23 PIRQ_VIA_IBASE 24}; 25 26/** 27 * Intel interrupt router control block 28 * 29 * Its members' value will be filled in based on device tree's input. 30 * 31 * @config: PIRQ_VIA_PCI or PIRQ_VIA_IBASE 32 * @link_base: link value base number 33 * @irq_mask: IRQ mask reprenting the 16 IRQs in 8259, bit N is 1 means 34 * IRQ N is available to be routed 35 * @lb_bdf: irq router's PCI bus/device/function number encoding 36 * @ibase: IBASE register block base address 37 * @actl_8bit: ACTL register width is 8-bit (for ICH series chipset) 38 * @actl_addr: ACTL register offset 39 */ 40struct irq_router { 41 int config; 42 u32 link_base; 43 u16 irq_mask; 44 u32 bdf; 45 u32 ibase; 46 bool actl_8bit; 47 int actl_addr; 48}; 49 50struct pirq_routing { 51 int bdf; 52 int pin; 53 int pirq; 54}; 55 56/* PIRQ link number and value conversion */ 57#define LINK_V2N(link, base) (link - base) 58#define LINK_N2V(link, base) (link + base) 59 60#define PIRQ_BITMAP 0xdef8 61 62/** 63 * irq_router_common_init() - Perform common x86 interrupt init 64 * 65 * This creates the PIRQ routing table and routes the IRQs 66 */ 67int irq_router_common_init(struct udevice *dev); 68 69#endif /* _ARCH_IRQ_H_ */ 70