LXR uboot/board/bluegiga/apx4devkit/apx4devkit.c

   1// SPDX-License-Identifier: GPL-2.0+
   2/*
   3 * Bluegiga APX4 Development Kit
   4 *
   5 * Copyright (C) 2012 Bluegiga Technologies Oy
   6 *
   7 * Authors:
   8 * Veli-Pekka Peltola <veli-pekka.peltola@bluegiga.com>
   9 * Lauri Hintsala <lauri.hintsala@bluegiga.com>
  10 *
  11 * Based on m28evk.c:
  12 * Copyright (C) 2011 Marek Vasut <marek.vasut@gmail.com>
  13 * on behalf of DENX Software Engineering GmbH
  14 */
  15
  16#include <common.h>
  17#include <asm/gpio.h>
  18#include <asm/io.h>
  19#include <asm/setup.h>
  20#include <asm/arch/imx-regs.h>
  21#include <asm/arch/iomux-mx28.h>
  22#include <asm/arch/clock.h>
  23#include <asm/arch/sys_proto.h>
  24#include <env.h>
  25#include <linux/mii.h>
  26#include <miiphy.h>
  27#include <netdev.h>
  28#include <errno.h>
  29
  30DECLARE_GLOBAL_DATA_PTR;
  31
  32/* Functions */
  33int board_early_init_f(void)
  34{
  35        /* IO0 clock at 480MHz */
  36        mxs_set_ioclk(MXC_IOCLK0, 480000);
  37        /* IO1 clock at 480MHz */
  38        mxs_set_ioclk(MXC_IOCLK1, 480000);
  39
  40        /* SSP0 clock at 96MHz */
  41        mxs_set_sspclk(MXC_SSPCLK0, 96000, 0);
  42
  43        return 0;
  44}
  45
  46int dram_init(void)
  47{
  48        return mxs_dram_init();
  49}
  50
  51int board_init(void)
  52{
  53        /* Adress of boot parameters */
  54        gd->bd->bi_boot_params = PHYS_SDRAM_1 + 0x100;
  55
  56        return 0;
  57}
  58
  59#ifdef CONFIG_CMD_MMC
  60int board_mmc_init(bd_t *bis)
  61{
  62        return mxsmmc_initialize(bis, 0, NULL, NULL);
  63}
  64#endif
  65
  66
  67#ifdef CONFIG_CMD_NET
  68
  69#define MII_PHY_CTRL2 0x1f
  70int fecmxc_mii_postcall(int phy)
  71{
  72        /* change PHY RMII clock to 50MHz */
  73        miiphy_write("FEC", 0, MII_PHY_CTRL2, 0x8180);
  74
  75        return 0;
  76}
  77
  78int board_eth_init(bd_t *bis)
  79{
  80        int ret;
  81        struct eth_device *dev;
  82
  83        ret = cpu_eth_init(bis);
  84        if (ret) {
  85                printf("FEC MXS: Unable to init FEC clocks\n");
  86                return ret;
  87        }
  88
  89        ret = fecmxc_initialize(bis);
  90        if (ret) {
  91                printf("FEC MXS: Unable to init FEC\n");
  92                return ret;
  93        }
  94
  95        dev = eth_get_dev_by_name("FEC");
  96        if (!dev) {
  97                printf("FEC MXS: Unable to get FEC device entry\n");
  98                return -EINVAL;
  99        }
 100
 101        ret = fecmxc_register_mii_postcall(dev, fecmxc_mii_postcall);
 102        if (ret) {
 103                printf("FEC MXS: Unable to register FEC MII postcall\n");
 104                return ret;
 105        }
 106
 107        return ret;
 108}
 109#endif
 110
 111#ifdef CONFIG_SERIAL_TAG
 112#define MXS_OCOTP_MAX_TIMEOUT 1000000
 113void get_board_serial(struct tag_serialnr *serialnr)
 114{
 115        struct mxs_ocotp_regs *ocotp_regs =
 116                (struct mxs_ocotp_regs *)MXS_OCOTP_BASE;
 117
 118        serialnr->high = 0;
 119        serialnr->low = 0;
 120
 121        writel(OCOTP_CTRL_RD_BANK_OPEN, &ocotp_regs->hw_ocotp_ctrl_set);
 122
 123        if (mxs_wait_mask_clr(&ocotp_regs->hw_ocotp_ctrl_reg, OCOTP_CTRL_BUSY,
 124                MXS_OCOTP_MAX_TIMEOUT)) {
 125                printf("MXS: Can't get serial number from OCOTP\n");
 126                return;
 127        }
 128
 129        serialnr->low = readl(&ocotp_regs->hw_ocotp_cust3);
 130}
 131#endif
 132
 133#ifdef CONFIG_REVISION_TAG
 134u32 get_board_rev(void)
 135{
 136        if (env_get("revision#") != NULL)
 137                return simple_strtoul(env_get("revision#"), NULL, 10);
 138        return 0;
 139}
 140#endif
 141