LXR uboot/drivers/thermal/Kconfig

   1config DM_THERMAL
   2        bool "Driver support for thermal devices"
   3        help
   4          Enable support for temperature-sensing devices. Some SoCs have on-chip
   5          temperature sensors to permit warnings, speed throttling or even
   6          automatic power-off when the temperature gets too high or low. Other
   7          devices may be discrete but connected on a suitable bus.
   8
   9if DM_THERMAL
  10
  11config IMX_THERMAL
  12        bool "Temperature sensor driver for Freescale i.MX SoCs"
  13        depends on MX6 || MX7
  14        help
  15          Support for Temperature Monitor (TEMPMON) found on Freescale i.MX SoCs.
  16          It supports one critical trip point and one passive trip point.  The
  17          cpufreq is used as the cooling device to throttle CPUs when the
  18          passive trip is crossed.
  19
  20config IMX_SCU_THERMAL
  21        bool "Temperature sensor driver for NXP i.MX8"
  22        depends on ARCH_IMX8
  23        help
  24          Support for Temperature sensors on NXP i.MX8.
  25          It supports one critical trip point and one passive trip point. The
  26          boot is hold to the cool device to throttle CPUs when the passive
  27          trip is crossed
  28
  29config IMX_TMU
  30        bool "Thermal Management Unit driver for NXP i.MX8M"
  31        depends on ARCH_IMX8M
  32        help
  33          Support for Temperature sensors on NXP i.MX8M.
  34          It supports one critical trip point and one passive trip point.
  35          The boot is hold to the cool device to throttle CPUs when the
  36          passive trip is crossed
  37
  38config TI_DRA7_THERMAL
  39        bool "Temperature sensor driver for TI dra7xx SOCs"
  40        help
  41         Enable thermal support for for the Texas Instruments DRA752 SoC family.
  42         The driver supports reading CPU temperature.
  43
  44endif # if DM_THERMAL
  45