LXR uboot/drivers/w1-eeprom/Kconfig

   1#
   2# EEPROM subsystem configuration
   3#
   4
   5menu "1-wire EEPROM support"
   6
   7config W1_EEPROM
   8        bool "Enable support for EEPROMs on 1wire interface"
   9        depends on DM
  10        help
  11          Support for the EEPROMs connected on 1-wire Dallas protocol interface
  12
  13if W1_EEPROM
  14
  15config W1_EEPROM_DS24XXX
  16        bool "Enable Maxim DS24 families EEPROM support"
  17        depends on W1
  18        help
  19          Maxim DS24 EEPROMs 1-Wire EEPROM support
  20
  21config W1_EEPROM_DS2502
  22        bool "Enable Maxim DS2502 Add-Only Memory support"
  23        depends on W1
  24        help
  25          Maxim DS2502 1-Wire add-only memory support.
  26          This device has 128 bytes of data memory, organized as 4 pages of
  27          32 bytes and 8 out of band status bytes that may be used to redirect
  28          pages, allowing data to be modified up to 4 times (by external
  29          programming).
  30
  31          The device may be seen as a 32 byte memory, using the page redirection
  32          or as a 128 byte memory, ignoring the page redirection.
  33
  34config W1_EEPROM_SANDBOX
  35        bool "Enable sandbox onewire EEPROM driver"
  36        depends on W1
  37        help
  38          Sandbox driver for a onewire EEPROM memory
  39
  40endif
  41
  42endmenu
  43